Suppr超能文献

三种交替桩反向半结(RHAPs)不同组合对关节镜下结完整性影响的验证

Validation of Different Combination of Three Reversing Half-Hitches Alternating Posts (RHAPs) Effects on Arthroscopic Knot Integrity.

作者信息

Chong Alexander Cm, Prohaska Daniel J, Bye Brian P

机构信息

Via Christi Health, Department of Graduate Medical Education, Wichita, KS.

University of Kansas School of Medicine-Wichita, Department of Orthopaedics, Wichita, KS.

出版信息

Kans J Med. 2017 May 15;10(2):35-39. eCollection 2017 May.

Abstract

INTRODUCTION

With arthroscopic techniques being used, the importance of knot tying has been examined. Previous literature has examined the use of reversing half-hitches on alternating posts (RHAPs) on knot security. Separately, there has been research regarding different suture materials commonly used in the operating room. The specific aim of this study was to validate the effect of different stacked half-hitch configuration and different braided suture materials on arthroscopic knot integrity.

METHODS

Three different suture materials tied with five different RHAPs in arthroscopic knots were compared. A single load-to-failure test was performed and the mean ultimate clinical failure load was obtained.

RESULTS

Significant knot holding strength improvement was found when one half-hitch was reversed as compared to baseline knot. When two of the half-hitches were reversed, there was a greater improvement with all knots having a mean ultimate clinical failure load greater than 150 newtons (N). Comparison of the suture materials demonstrated a higher mean ultimate clinical failure load when Force Fiber was used and at least one half-hitch was reversed. Knots tied with either Force Fiber or Orthocord showed 0% chance of knot slippage while knots tied with FiberWire or braided fishing line had about 10 and 30% knot slippage chances, respectively.

CONCLUSIONS

A significant effect was observed in regards to both stacked half-hitch configuration and suture materials used on knot loop and knot security. Caution should be used with tying three RHAPs in arthroscopic surgery, particularly with a standard knot pusher and arthroscopic cannulas. The findings of this study indicated the importance of three RHAPs in performing arthroscopic knot tying and provided evidence regarding discrepancies of maximum clinical failure loads observed between orthopaedic surgeons, thereby leading to better surgical outcomes in the future.

摘要

引言

随着关节镜技术的应用,打结的重要性已得到研究。既往文献探讨了在交替柱上使用反向半结(RHAPs)对结安全性的影响。另外,也有关于手术室常用不同缝合材料的研究。本研究的具体目的是验证不同堆叠半结构型和不同编织缝合材料对关节镜下结完整性的影响。

方法

比较了在关节镜结中用三种不同缝合材料与五种不同的RHAPs打结的情况。进行了单次失效载荷试验,并获得了平均最终临床失效载荷。

结果

与基线结相比,当一个半结反向时,结的握持强度有显著提高。当两个半结反向时,所有结的平均最终临床失效载荷均大于150牛顿(N),有更大的改善。缝合材料的比较表明,使用Force Fiber且至少一个半结反向时,平均最终临床失效载荷更高。用Force Fiber或Orthocord打结的结滑脱几率为0%,而用FiberWire或编织钓鱼线打结的结分别有大约10%和30%的滑脱几率。

结论

观察到堆叠半结构型和所用缝合材料对结环和结安全性均有显著影响。在关节镜手术中打结三个RHAPs时应谨慎,尤其是使用标准结推器和关节镜套管时。本研究结果表明了三个RHAPs在进行关节镜打结中的重要性,并提供了关于骨科医生观察到的最大临床失效载荷差异的证据,从而在未来带来更好的手术结果。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/968e/5733413/0f6cf2893c4a/kjm-10-2-35f1.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验