Chang Jee Hae, Hwang Chung-Ju, Kim Kyung-Ho, Cha Jung-Yul, Kim Kwang-Mahn, Yu Hyung Seog
Department of Orthodontics, College of Dentistry, Yonsei University, Seoul, Korea.
Institute of Craniofacial Deformity, College of Dentistry, Yonsei University, Seoul, Korea.
Korean J Orthod. 2018 Nov;48(6):384-394. doi: 10.4041/kjod.2018.48.6.384. Epub 2018 Sep 14.
This study was performed to investigate an appropriate degree of prestretch for orthodontic synthetic elastomeric chains focusing on time-dependent viscoelastic properties.
Orthodontic synthetic elastomeric chains of two brands were prestretched to 50, 100, 150, and 200% of the original length in one and three cycles, and the hysteresis areas of the obtained stress-strain curves were determined. Acrylic plates were employed to maintain constant strain during the experiment. A total of 180 samples were classified into nine groups according to brand, and their stresses and permanent deformations were measured immediately after prestretch (0 hour), after 1 hour and 24 hours, and after 1, 2, 3, 4, 5, 6, 7, and 8 weeks. The relationship between stress relaxation and permanent deformation was investigated for various degrees of prestretch, and the estimated stress resulting from tooth movement was calculated.
The degree of prestretch and the stress relaxation ratio exhibited a strong negative correlation, whereas no correlation was found between the degree of prestretch and the average normalized permanent strain. The maximal estimated stress was observed when prestretch was performed in three cycles to 200% of the original length.
Although prestretch benefited residual stress, it did not exhibit negative effects such as permanent deformation. The maximal estimated stress was observed at the maximal prestretch, but the difference between prestretch and control groups decreased with time. In general, higher residual stresses were observed for product B than for product A, but this difference was not clinically significant.
本研究旨在研究正畸合成弹性链的适当预拉伸程度,重点关注随时间变化的粘弹性特性。
将两个品牌的正畸合成弹性链在一个和三个循环中预拉伸至原始长度的50%、100%、150%和200%,并测定所得应力-应变曲线的滞后面积。在实验过程中使用丙烯酸板来保持恒定应变。根据品牌将总共180个样本分为九组,并在预拉伸后立即(0小时)、1小时和24小时后以及1、2、3、4、5、6、7和8周后测量其应力和永久变形。研究了不同预拉伸程度下应力松弛与永久变形之间的关系,并计算了牙齿移动产生的估计应力。
预拉伸程度与应力松弛率呈强负相关,而预拉伸程度与平均归一化永久应变之间未发现相关性。当在三个循环中预拉伸至原始长度的200%时,观察到最大估计应力。
尽管预拉伸有利于残余应力,但它并未表现出诸如永久变形等负面影响。在最大预拉伸时观察到最大估计应力,但预拉伸组与对照组之间的差异随时间减小。一般来说,产品B的残余应力高于产品A,但这种差异在临床上并不显著。