Comparison of Acoustic Streaming Flow Patterns Induced by Solid, Liquid and Gas Obstructions.

In this study, acoustic streaming flows inside micro-channels induced by three different types of obstruction-gaseous bubble, liquid droplet and solid bulge-are compared and investigated experimentally by particle tracking velocimetry (PTV) and numerically using the finite element method (FEM). The micro-channels are made by poly(dimethylsiloxane) (PDMS) using soft lithography with low-cost micro-machined mold. The characteristic dimensions of the media are 0.2 mm in diameter, and the oscillation generated by piezoelectric actuators has frequency of 12 kHz and input voltages of 40 V. The experimental results show that in all three obstruction types, a pair of counter-rotating vortical patterns were observed around the semi-circular obstructions. The gaseous bubble creates the strongest vortical streaming flow, which can reach a maximum of 21 mm/s, and the largest u component happens at Y/D = 0. The solid case is the weakest of the three, which can only reach 2 mm/s. The liquid droplet has the largest components and speed at Y/D = 0.5 and Y/D = 0.6. Because of the higher density and incompressibility of liquid droplet compared to the gaseous bubble, the liquid droplet obstruction transfers the oscillation of the piezo plate most efficiently, and the induced streaming flow region and average speed are both the largest of the three. An investigation using numerical simulation shows that the differing interfacial conditions between the varying types of obstruction boundaries to the fluid may be the key factor to these differences. These results suggest that it might be more energy-efficient to design an acoustofluidic device using a liquid droplet obstruction to induce the stronger streaming flow.