Li Wei-Qin, Mu Chao-Yi
School of Automation and Information Engineering, Xi'an University of Technology, Xi'an 710048, PR China.
Xi'an Research Institute of Applied Optics, Xi'an 710065, PR China.
Micron. 2021 Jan;140:102961. doi: 10.1016/j.micron.2020.102961. Epub 2020 Oct 13.
In this work, the charging effect and induced conductivity of SiO thin films on Si substrate irradiated by penetrating electron beam (e-beam) are investigated based on numerical calculation and experiment. The numerical model is performed by considering the electron scattering, trapping, drift, diffusion and recombination, and solved by the Monte Carlo and finite difference method. The results show that, under e-beam irradiation, due to emission of secondary electrons (SEs) from the surface, the net charge density is positive near the surface, but negative inside the film. The net charge density and resulting negative charging intensity decrease under e-beam irradiation because of high electron mobility. With e-beam irradiation, the free electrons drift and diffuse to the meter and thus the sample current increases. Meanwhile, the transmission current remains unchanged due to the weak charging intensity. With the increasing beam energy, the transmission current increases to the beam current. The sample current and the induced current gain reach the maximum at the beam energy of 15 keV. The sample current and the induced conductivity at the steady state increase linearly with beam current. The induced current gain increases with the rising positive bias voltage. The influence of film parameters on the charge effect is also analyzed.
在本工作中,基于数值计算和实验研究了穿透电子束(电子束)辐照下硅衬底上SiO薄膜的充电效应和感应电导率。通过考虑电子散射、俘获、漂移、扩散和复合来建立数值模型,并采用蒙特卡罗方法和有限差分法求解。结果表明,在电子束辐照下,由于表面二次电子(SEs)的发射,表面附近的净电荷密度为正,而薄膜内部为负。由于高电子迁移率,电子束辐照下净电荷密度和由此产生的负充电强度降低。随着电子束辐照,自由电子漂移并扩散到计中,从而样品电流增加。同时,由于充电强度较弱,传输电流保持不变。随着束流能量的增加,传输电流增加到束流。样品电流和感应电流增益在束流能量为15 keV时达到最大值。稳态下的样品电流和感应电导率随束流线性增加。感应电流增益随正偏压的升高而增加。还分析了薄膜参数对电荷效应的影响。