Suppr超能文献

导致类风湿关节炎患者硅橡胶掌指关节成形术后早期假体骨折的危险因素。

Risk Factors Contributing to Early Implant Fracture in Silicone Metacarpophalangeal Joint Arthroplasty for Patients With Rheumatoid Arthritis.

机构信息

Department of Orthopaedic Surgery, Keio University School of Medicine, Tokyo, Japan.

Department of Orthopaedic Surgery, Keio University School of Medicine, Tokyo, Japan.

出版信息

J Hand Surg Am. 2021 Mar;46(3):243.e1-243.e7. doi: 10.1016/j.jhsa.2020.09.002. Epub 2020 Nov 6.

Abstract

PURPOSE

To identify the risk factors associated with early implant fracture of silicone metacarpophalangeal (MCP) joint arthroplasty using the volar hinge silicone implant for patients with rheumatoid arthritis.

METHODS

We retrospectively reviewed 113 fingers of 31 hands that underwent MCP joint arthroplasty between 2008 and 2014, with a minimum follow-up of 3 years,. An implant fracture within 3 years after surgery was regarded as an early implant fracture. Patient records were reviewed for potential risk factors of age, affected fingers, ulnar drift angle, and range of motion of the MCP joint before surgery and 1 year after surgery. Candidate risk factors were compared at the level of the digit and at the patient level.

RESULTS

With fracture of the implants as the end point, Kaplan-Meier estimated survival rate was 74.3% at 3 years and 67.9% at 5 years. Early implant fracture was detected in 29 fingers. Bivariate analyses showed significant associations between early implant fracture and MCP joint arc of motion before surgery, MCP joint flexion range 1 year after surgery, and MCP joint arc of motion 1 year after surgery. Multiple logistic regression analysis showed that increased MCP joint flexion range 1 year after surgery was an independent risk factor for early implant fracture.

CONCLUSIONS

Increasing MCP joint flexion range was associated with increased fractures of the implants. We propose that the MCP joint flexion range should be restricted to less than 60° in postoperative rehabilitation; it is necessary to educate the patient to permanently avoid excessive flexion of the MCP joint.

TYPE OF STUDY/LEVEL OF EVIDENCE: Therapeutic IV.

摘要

目的

通过使用掌侧铰链式硅橡胶指间关节成形术治疗类风湿关节炎患者,确定与硅橡胶掌指(MCP)关节成形术后早期植入物骨折相关的危险因素。

方法

我们回顾性分析了 2008 年至 2014 年间接受 MCP 关节成形术的 31 只手的 113 个手指,随访时间至少为 3 年。术后 3 年内发生的植入物骨折被认为是早期植入物骨折。我们对患者的年龄、受累手指、尺侧漂移角和 MCP 关节术前及术后 1 年的关节活动度等潜在危险因素进行了病历回顾。在手指水平和患者水平上比较了候选危险因素。

结果

以植入物骨折为终点,Kaplan-Meier 估计术后 3 年的生存率为 74.3%,术后 5 年的生存率为 67.9%。29 个手指发现早期植入物骨折。双变量分析显示,早期植入物骨折与术前 MCP 关节活动度、术后 1 年 MCP 关节屈曲范围和术后 1 年 MCP 关节活动度显著相关。多因素逻辑回归分析显示,术后 1 年 MCP 关节屈曲范围增加是早期植入物骨折的独立危险因素。

结论

MCP 关节屈曲范围的增加与植入物骨折的增加有关。我们建议术后康复时 MCP 关节屈曲范围应限制在 60°以内;有必要教育患者避免 MCP 关节过度屈曲。

研究类型/证据水平:治疗性 IV 级。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验