Abyzov Alexander S, Schmelzer Jürn W P, Fokin Vladimir M, Zanotto Edgar D
National Science Center, Kharkov Institute of Physics and Technology, 61108 Kharkov, Ukraine.
Institut für Physik der Universität Rostock, Albert-Einstein-Strasse 23-25, 18059 Rostock, Germany.
Entropy (Basel). 2020 May 16;22(5):558. doi: 10.3390/e22050558.
Crystal nucleation can be described by a set of kinetic equations that appropriately account for both the thermodynamic and kinetic factors governing this process. The mathematical analysis of this set of equations allows one to formulate analytical expressions for the basic characteristics of nucleation, i.e., the steady-state nucleation rate and the steady-state cluster-size distribution. These two quantities depend on the work of formation, Δ G ( n ) = - n Δ μ + γ n 2 / 3 , of crystal clusters of size and, in particular, on the work of critical cluster formation, Δ G ( n c ) . The first term in the expression for Δ G ( n ) describes changes in the bulk contributions (expressed by the chemical potential difference, Δ μ ) to the Gibbs free energy caused by cluster formation, whereas the second one reflects surface contributions (expressed by the surface tension, σ : γ = Ω d 0 2 σ , Ω = 4 π ( 3 / 4 π ) 2 / 3 , where d 0 is a parameter describing the size of the particles in the liquid undergoing crystallization), is the number of particles (atoms or molecules) in a crystallite, and n = n c defines the size of the critical crystallite, corresponding to the maximum (in general, a saddle point) of the Gibbs free energy, . The work of cluster formation is commonly identified with the difference between the Gibbs free energy of a system containing a cluster with particles and the homogeneous initial state. For the formation of a "cluster" of size n = 1 , no work is required. However, the commonly used relation for Δ G ( n ) given above leads to a finite value for n = 1 . By this reason, for a correct determination of the work of cluster formation, a self-consistency correction should be introduced employing instead of Δ G ( n ) an expression of the form Δ G ˜ ( n ) = Δ G ( n ) - Δ G ( 1 ) . Such self-consistency correction is usually omitted assuming that the inequality Δ G ( n ) ≫ Δ G ( 1 ) holds. In the present paper, we show that: (i) This inequality is frequently not fulfilled in crystal nucleation processes. (ii) The form and the results of the numerical solution of the set of kinetic equations are not affected by self-consistency corrections. However, (iii) the predictions of the analytical relations for the steady-state nucleation rate and the steady-state cluster-size distribution differ considerably in dependence of whether such correction is introduced or not. In particular, neglecting the self-consistency correction overestimates the work of critical cluster formation and leads, consequently, to far too low theoretical values for the steady-state nucleation rates. For the system studied here as a typical example (lithium disilicate, Li 2 O · 2 SiO 2 ), the resulting deviations from the correct values may reach 20 orders of magnitude. Consequently, neglecting self-consistency corrections may result in severe errors in the interpretation of experimental data if, as it is usually done, the analytical relations for the steady-state nucleation rate or the steady-state cluster-size distribution are employed for their determination.
晶体成核可用一组动力学方程来描述,这些方程恰当地考虑了控制此过程的热力学和动力学因素。对这组方程进行数学分析,可使人得出成核基本特征的解析表达式,即稳态成核速率和稳态团簇尺寸分布。这两个量取决于尺寸为的晶体团簇的形成功ΔG(n)= -nΔμ + γn2/3,尤其取决于临界团簇形成功ΔG(nc)。ΔG(n)表达式中的第一项描述了由于团簇形成而对吉布斯自由能产生的体相贡献变化(由化学势差Δμ表示),而第二项反映了表面贡献(由表面张力σ表示:γ = Ωd02σ,Ω = 4π(3/4π)2/3,其中d0是描述正在结晶的液体中颗粒尺寸的参数),是微晶中的颗粒(原子或分子)数,且n = nc定义了临界微晶的尺寸,对应于吉布斯自由能的最大值(一般为鞍点)。团簇形成功通常被认为是包含n个颗粒的团簇的系统的吉布斯自由能与均匀初始状态之间的差值。对于尺寸n = 1的“团簇”形成,不需要功。然而,上述常用的ΔG(n)关系式在n = 1时会得出一个有限值。因此,为了正确确定团簇形成功,应引入自洽校正,用ΔG˜(n)=ΔG(n)-ΔG(1)的表达式代替ΔG(n)。通常假定不等式ΔG(n)≫ΔG(1)成立,从而省略这种自洽校正。在本文中,我们表明:(i) 这种不等式在晶体成核过程中经常不成立。(ii) 这组动力学方程的数值解的形式和结果不受自洽校正的影响。然而,(iii) 对于稳态成核速率和稳态团簇尺寸分布的解析关系式的预测,根据是否引入这种校正而有很大差异。特别是,忽略自洽校正会高估临界团簇形成功,从而导致稳态成核速率的理论值过低。对于此处作为典型例子研究的系统(二硅酸锂,Li2O·2SiO2),由此产生的与正确值的偏差可能达到20个数量级。因此,如果像通常那样使用稳态成核速率或稳态团簇尺寸分布的解析关系式来确定实验数据,忽略自洽校正可能会在实验数据的解释中导致严重错误。