Specht Mariusz
Department of Transport and Logistics, Gdynia Maritime University, Morska 81-87, 81-225 Gdynia, Poland.
Sensors (Basel). 2020 Dec 13;20(24):7144. doi: 10.3390/s20247144.
Positioning systems are used to determine position coordinates in navigation (air, land, and marine). Statistical analysis of their accuracy assumes that the position errors (latitude- and longitude-) are random and that their distributions are consistent with the normal distribution. However, in practice, these errors do not appear in a random way, since the position determination in navigation systems is done with an iterative method. It causes so-called "", similar to the term "" known from statistics. It results in the empirical distribution of and being inconsistent with the normal distribution, even for samples of up to several thousand measurements. This phenomenon results in a significant overestimation of the accuracy of position determination calculated from such a short series of measurements, causing these tests to lose their representativeness. This paper attempts to determine the length of a measurement session (number of measurements) that is representative of the positioning system. This will be a measurement session of such a length that the position error statistics ( and ) represented by the standard deviation values are close to the real values and the calculated mean values (φ¯ and λ¯) are also close to the real values. Special attention will also be paid to the selection of an appropriate (statistically reliable) number of measurements to be tested statistically to verify the hypothesis that the and distributions are consistent with the normal distribution. Empirical measurement data are taken from different positioning systems: Global Positioning System (GPS) (168'286 fixes), Differential Global Positioning System (DGPS) (864'000 fixes), European Geostationary Navigation Overlay Service (EGNOS) (928'492 fixes), and Decca Navigator system (4052 fixes). The analyses showed that all researched positioning systems (GPS, DGPS, EGNOS and Decca Navigator) are characterized by the Position Random Walk (PRW), which resulted in that the empirical distribution of and being inconsistent with the normal distribution. The size of the PRW depends on the nominal accuracy of position determination by the system. It was found that measurement sessions consisting of 1000 fixes (for the GPS system) overestimate the accuracy analysis results by 109.1% and cannot be considered representative. Furthermore, when analyzing the results of long measurement campaigns (GPS and DGPS), it was found that the representative length of the measurement session differs for each positioning system and should be determined for each of them individually.
定位系统用于在导航(空中、陆地和海洋)中确定位置坐标。对其精度进行统计分析时,假定位置误差(纬度和经度)是随机的,且其分布符合正态分布。然而,在实际中,这些误差并非以随机方式出现,因为导航系统中的位置确定是通过迭代方法完成的。这会导致所谓的“”,类似于统计学中已知的“”术语。即使对于多达数千次测量的样本,也会导致和的经验分布与正态分布不一致。这种现象会导致根据如此短的一系列测量计算出的位置确定精度被显著高估,从而使这些测试失去代表性。本文试图确定代表定位系统的测量会话长度(测量次数)。这将是一个具有这样长度的测量会话,即由标准差表示的位置误差统计量(和)接近真实值,并且计算出的平均值(φ¯和λ¯)也接近真实值。还将特别关注选择合适的(统计上可靠的)测量次数进行统计测试,以验证和分布与正态分布一致的假设。经验测量数据取自不同的定位系统:全球定位系统(GPS)(168286个定位点)、差分全球定位系统(DGPS)(864000个定位点)、欧洲对地静止导航覆盖服务(EGNOS)(928492个定位点)和台卡导航系统(4052个定位点)。分析表明,所有研究的定位系统(GPS、DGPS、EGNOS和台卡导航系统)都具有位置随机游走(PRW)的特征,这导致和的经验分布与正态分布不一致。PRW的大小取决于系统位置确定的标称精度。结果发现,由1000个定位点组成的测量会话(对于GPS系统)将精度分析结果高估了109.1%,不能被视为具有代表性。此外,在分析长期测量活动(GPS和DGPS)的结果时发现,每个定位系统的测量会话代表长度不同,应分别为每个系统确定。