Kesarwani Himanshu, Sharma Shivanjali, Mandal Ajay
Department of Petroleum Engineering and Geological Sciences, Rajiv Gandhi Institute of Petroleum Technology, Jais 229304, India.
Department of Petroleum Engineering Indian Institute of Technology (ISM), Enhanced Oil Recovery Laboratory, Dhanbad 826004, India.
ACS Omega. 2021 Apr 19;6(17):11327-11339. doi: 10.1021/acsomega.1c00296. eCollection 2021 May 4.
Surfactant polymer flooding is one of the most common chemical enhanced oil recovery techniques, which improves not only the microscopic displacement of the fluid through the formation of the emulsion but also the volumetric sweep efficiency of the fluid by altering the viscosity of the displacing fluid. However, one constraint of surfactant flooding is the loss of the surfactant by adsorption onto the reservoir rock surface. Hence, in this study, an attempt has been made to reduce the adsorption of the surfactant on the rock surface using novel colloidal silica nanoparticles (CSNs). CSNs were used as an additive to improve the performance of the conventional surfactant polymer flooding. The reduction in adsorption was observed in both the presence and absence of a polymer. The presence of a polymer also reduced the adsorption of the surfactant. Addition of 25 vol % CSNs effectively reduced the adsorption of up to 61% in the absence of a polymer, which increased to 64% upon the introduction of 1000 ppm polymer in the solution at 2500 ppm of the surfactant concentration at 25 °C. The adsorption of surfactant was also monitored with time, and it was found to be increasing with respect to time. The adsorption of surfactant increased from 1.292 mg/g after 0.5 days to 4.179 mg/g after 4 days at 2500 ppm of surfactant concentration at 25 °C. The viscosity, surface tension, and wettability studies were also conducted on the chemical slug used for flooding. The addition of CSNs effectively reduced the surface tension as well as shifted the wettability toward water-wet at 25 °C. Sand pack flooding experiments were performed at 60 °C to access the potential of CSNs in oil recovery, and it was found that the addition of 25 vol % CSNs in the conventional surfactant polymer chemical slug aided in the additional oil recovery up to 5% as compared to that of the conventional surfactant polymer slug.
表面活性剂聚合物驱油是最常见的化学强化采油技术之一,它不仅通过形成乳液改善了流体在油层中的微观驱替,还通过改变驱替流体的粘度提高了流体的体积波及效率。然而,表面活性剂驱油的一个限制是表面活性剂会吸附在储层岩石表面而损失。因此,在本研究中,尝试使用新型胶体二氧化硅纳米颗粒(CSNs)来减少表面活性剂在岩石表面的吸附。CSNs被用作添加剂以改善传统表面活性剂聚合物驱油的性能。在有聚合物和无聚合物的情况下均观察到吸附量的减少。聚合物的存在也降低了表面活性剂的吸附。在25℃下,当表面活性剂浓度为2500 ppm时,添加25体积%的CSNs在无聚合物的情况下能有效降低高达61%的吸附量,当溶液中引入1000 ppm聚合物时,吸附量降低至64%。还监测了表面活性剂的吸附随时间的变化,发现其随时间增加。在25℃下,当表面活性剂浓度为2500 ppm时,表面活性剂的吸附量从0.5天后的1.292 mg/g增加到4天后的4.179 mg/g。还对用于驱油的化学段塞进行了粘度、表面张力和润湿性研究。在25℃下,添加CSNs有效降低了表面张力,并使润湿性向水湿转变。在60℃下进行了砂柱驱油实验以评估CSNs在采油中的潜力,结果发现,与传统表面活性剂聚合物段塞相比,在传统表面活性剂聚合物化学段塞中添加25体积%的CSNs有助于额外提高5%的采油量。