Suppr超能文献

聚(N-异丙基丙烯酰胺)刷表面的末端阳离子化有助于对细胞黏附与脱离进行高效的热响应控制。

Terminal cationization of poly(-isopropylacrylamide) brush surfaces facilitates efficient thermoresponsive control of cell adhesion and detachment.

作者信息

Nakayama Masamichi, Kanno Tomonori, Takahashi Hironobu, Kikuchi Akihiko, Yamato Masayuki, Okano Teruo

机构信息

Institute of Advanced Biomedical Engineering and Science, Tokyo Women's Medical University, Shinjuku, Japan.

Department of Materials Science and Technology, Graduate School of Advanced Engineering, Tokyo University of Science, Katsushika, Japan.

出版信息

Sci Technol Adv Mater. 2021 Jun 22;22(1):481-493. doi: 10.1080/14686996.2021.1929464.

Abstract

A variety of poly(-isopropylacrylamide) (PIPAAm)-grafted surfaces have been reported for temperature-controlled cell adhesion/detachment. However, the surfaces reported to date need further improvement to achieve good outcomes for both cell adhesion and detachment, which are inherently contradictory behaviors. This study investigated the effects of terminal cationization and length of grafted PIPAAm chains on temperature-dependent cell behavior. PIPAAm brushes with three chain lengths were constructed on glass coverslips via surface-initiated reversible addition-fragmentation chain transfer (RAFT) polymerization. Terminal substitution of the grafted PIPAAm chains with either monocationic trimethylammonium or nonionic isopropyl moieties was performed through the reduction of terminal RAFT-related groups and subsequent thiol-ene reaction with the corresponding acrylamide derivatives. Although the thermoresponsive properties of the PIPAAm brush surfaces were scarcely affected by the terminal functional moiety, the zeta potentials of the cationized PIPAAm surfaces were higher than those of the nonionized ones, both below and above the phase transition temperature of PIPAAm (30°C). When bovine endothelial cells were cultured on each surface at 37°C, the number of adherent cells decreased with longer PIPAAm. Notably, cell adhesion on the cationized PIPAAm surfaces was higher than that on the nonionized surfaces. This terminal effect on cell adhesion gradually weakened with increasing PIPAAm length. In particular, long-chain PIPAAm brushes virtually showed cell repellency even at 37°C, regardless of the termini. Interestingly, moderately long-chain PIPAAm brushes promoted cell detachment at 20°C, with negligible terminal electrostatic interruption. Consequently, both cell adhesion and detachment were successfully improved by choosing an appropriate PIPAAm length with terminal cationization.

摘要

据报道,多种接枝了聚(N-异丙基丙烯酰胺)(PIPAAm)的表面可用于温度控制的细胞黏附/脱离。然而,迄今为止报道的表面需要进一步改进,以实现细胞黏附和脱离的良好效果,而这两种行为本质上是相互矛盾的。本研究调查了接枝的PIPAAm链的末端阳离子化和链长对温度依赖性细胞行为的影响。通过表面引发的可逆加成-断裂链转移(RAFT)聚合反应,在玻璃盖玻片上构建了具有三种链长的PIPAAm刷。通过还原末端与RAFT相关的基团,随后与相应的丙烯酰胺衍生物进行硫醇-烯反应,对接枝的PIPAAm链进行末端单阳离子三甲基铵或非离子异丙基部分的取代。尽管PIPAAm刷表面的热响应特性几乎不受末端功能部分的影响,但阳离子化的PIPAAm表面的zeta电位在PIPAAm的相变温度(30°C)以下和以上均高于非离子化表面。当牛内皮细胞在每个表面上于37°C培养时,黏附细胞的数量随着PIPAAm链长的增加而减少。值得注意的是,阳离子化的PIPAAm表面上的细胞黏附高于非离子化表面。这种对细胞黏附的末端效应随着PIPAAm链长的增加而逐渐减弱。特别是,长链PIPAAm刷即使在37°C时也几乎表现出细胞排斥性,与末端无关。有趣的是,中等长度链的PIPAAm刷在20°C时促进细胞脱离,末端静电干扰可忽略不计。因此,通过选择具有末端阳离子化的合适PIPAAm链长,成功地改善了细胞黏附和脱离。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/e555/8221160/4d6bcaeb962d/TSTA_A_1929464_UF0001_OC.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验