Shaban Nadia Z, Kenawy Marwa Y, Taha Nahla A, Abd El-Latif Mona M, Ghareeb Doaa A
Biochemistry Department, Faculty of Science, Alexandria University, Alexandria 21511, Egypt.
Fabrication Technology Researches Department, Advanced Technology and New Materials Research Institute (ATNMRI), City of Scientific Research and Technological Applications (SRTA-City), New Borg El-Arab, Alexandria 21934, Egypt.
Polymers (Basel). 2021 Nov 27;13(23):4140. doi: 10.3390/polym13234140.
The specific objective of this study was to stabilize a simple valid method to prepare pure nanorod hydroxyapatite (HA) mixed with berberine chloride (BER) and Moghat water extract (ME) as composites for incorporation into cellulose acetate (CA) nanofibers to be used as novel bone scaffolds and to determine their efficacy in bone regeneration process In Vitro. Preparation of HA/BER and HA/ME composites were performed by mixing powders using the ball-milling machine. The HA, HA/BER, and HA/ME composites at a concentration of 6.25, 12.5, 25, 50, 100, and 200 mg were mixed with CA solution (13%), then the fiber was formed using electrospinning technique. The properties of the obtained CA fibers were investigated (SEM, TEM, EDX, FTIR, TGA, water uptake, porosity, and mechanical tests). The efficacy of HA and HA composites loaded into CA nanofiber on osteoblast and osteoclast differentiation were measured by tacking ALP, osteocalcin, TRAcP, calcium, and total protein concentration. Moreover, their effects on cell differentiation (CD90 and PARP- ɣ) and death markers (GSK3b, MAPK, Wnt-5 and β-catenin) were evaluated by using ELISA and qPCR. The obtained TEM results indicated that the continuous CA and CA/HA composites electrospun fibers have ultrafine fiber diameters of about 200 nm and uniform distribution of discrete n-HA clusters throughout. In addition, hydrocortisone (HCT) was found to increase the formation of adipocytes and osteoclastic markers CD90 and p38-MAPK which indicated the bone lose process take placed. Treatment with CA loaded with HA, HA/BER or HA/ME decreased CD90, Wnt-5, PARP- ɣ, GSK3b and p38-MAPK associated elevation of osteogenic markers: ALP and osteocalcin. Moreover, HCT overexpressed RANKL and down expressed Osterix gene. Treatment with CA/HA/BER or CA/HA/ME downregulated RANKL and upregulated Osterix associated with a reduction in RANKL/OPG ratio, at < 0.05. In conclusion, novel CA composite nanofibers (CA/HA/BER and CA/HA/ME) reversed the HCT adverse effect on osteoblast cell death through canonical and non-canonical pathways regulated by Wnt/β-catenin and Wnt/Ca() pathways. Furthermore, our data confirmed that the novel scaffolds create a crosstalk between RUNX-2, RANKL, p38-MAPK, and Wnt signals which positively impact bone regeneration process. Treatment with CA/HA/BER is better compared to the treatment with CA/HA/ME. Nevertheless, both are considered as alternative biomaterial scaffolds with a potential for biomedical applications in the field of bone tissue engineering.
本研究的具体目标是稳定一种简单有效的方法,制备与黄连素(BER)和莫加特水提取物(ME)混合的纯纳米棒状羟基磷灰石(HA)复合材料,将其掺入醋酸纤维素(CA)纳米纤维中用作新型骨支架,并在体外确定它们在骨再生过程中的功效。通过使用球磨机混合粉末来制备HA/BER和HA/ME复合材料。将浓度为6.25、12.5、25、50、100和200mg的HA、HA/BER和HA/ME复合材料与CA溶液(13%)混合,然后使用静电纺丝技术形成纤维。研究了所得CA纤维的性能(扫描电子显微镜、透射电子显微镜、能谱分析、傅里叶变换红外光谱、热重分析、吸水率、孔隙率和力学测试)。通过检测碱性磷酸酶、骨钙素、抗酒石酸酸性磷酸酶、钙和总蛋白浓度,测量负载于CA纳米纤维中的HA和HA复合材料对成骨细胞和破骨细胞分化的功效。此外,通过酶联免疫吸附测定和定量聚合酶链反应评估它们对细胞分化(CD90和聚(ADP-核糖)聚合酶γ)和死亡标志物(糖原合成酶激酶3β、丝裂原活化蛋白激酶、Wnt-5和β-连环蛋白)的影响。所得透射电子显微镜结果表明,连续的CA和CA/HA复合材料静电纺丝纤维具有约200nm的超细纤维直径,并且离散的纳米HA簇均匀分布。此外,发现氢化可的松(HCT)增加脂肪细胞的形成以及破骨细胞标志物CD90和p38-丝裂原活化蛋白激酶,这表明发生了骨质流失过程。用负载HA、HA/BER或HA/ME的CA处理可降低与成骨标志物碱性磷酸酶和骨钙素升高相关的CD90、Wnt-5、聚(ADP-核糖)聚合酶γ、糖原合成酶激酶3β和p38-丝裂原活化蛋白激酶。此外,HCT使核因子κB受体活化因子配体过表达并使osterix基因下调。用CA/HA/BER或CA/HA/ME处理下调核因子κB受体活化因子配体并上调osterix,同时核因子κB受体活化因子配体/骨保护素比值降低,P<0.05。总之,新型CA复合纳米纤维(CA/HA/BER和CA/HA/ME)通过Wnt/β-连环蛋白和Wnt/Ca²⁺途径调节的经典和非经典途径逆转了HCT对成骨细胞死亡的不利影响。此外,我们的数据证实,新型支架在RUNX-2、核因子κB受体活化因子配体、p38-丝裂原活化蛋白激酶和Wnt信号之间产生串扰,这对骨再生过程产生积极影响。与用CA/HA/ME处理相比,用CA/HA/BER处理效果更好。然而,两者都被认为是在骨组织工程领域具有生物医学应用潜力的替代生物材料支架。