Anshuman Aashu, Saremi-Yarahmadi Sina, Vaidhyanathan Bala
Department of Materials, Loughborough University Loughborough LE11 3TU UK
RSC Adv. 2018 Feb 16;8(14):7709-7715. doi: 10.1039/c8ra00031j. eCollection 2018 Feb 14.
Towards achieving efficient waste water treatment, the degradation of a common water pollutant, Orange G azo dye, was studied using a new hybrid catalyst and microwave irradiation. The fabrication of a hybrid catalyst based on reduced graphene oxide-titania (rGO-TiO), was first achieved in a single mode microwave cavity by reducing the precursor consisting of graphene oxide (GO) and titania. Catalytic performance was then assessed in both microwave assisted and conventional heat treatment conditions. The hybrid catalyst showed significant improvement under microwave irradiation, with more than 88% dye degradation after 20 minutes of treatment at 120 °C. The microwave effect was found to be more dominant in the early stages of the catalysis - the hybrid catalyst decomposed ∼65% of the dye in just 5 minutes of microwave treatment compared to only 18% degradation obtained during conventional heating. The improved performance with microwaves is mainly attributed to the formation of the hot spots at the surface of the hybrid catalyst which ultimately results in higher degradation rates. The morphological and catalytic properties of the hybrid catalyst are investigated using High Resolution Transmission Electron Microscopy (HRTEM) and UV-Vis Spectroscopy, respectively. Successful reduction of GO to rGO was confirmed using Raman spectroscopy and X-ray diffraction. The outstanding performance of microwave irradiated hybrids offers a viable low energy, low carbon footprint process with a new catalyst for wastewater treatment and for highly polluted wastewater conditions where photocatalysis is deemed not feasible.
为了实现高效的废水处理,使用一种新型混合催化剂和微波辐射研究了一种常见的水污染物——橙色G偶氮染料的降解情况。基于还原氧化石墨烯-二氧化钛(rGO-TiO)的混合催化剂的制备,首先是在单模微波腔中通过还原由氧化石墨烯(GO)和二氧化钛组成的前驱体来实现的。然后在微波辅助和传统热处理条件下评估催化性能。该混合催化剂在微波辐射下表现出显著的改善,在120°C下处理20分钟后,染料降解率超过88%。发现微波效应在催化的早期阶段更为显著——与传统加热仅获得18%的降解率相比,混合催化剂在微波处理仅5分钟内就分解了约65%的染料。微波处理性能的提高主要归因于混合催化剂表面形成的热点,这最终导致了更高的降解率。分别使用高分辨率透射电子显微镜(HRTEM)和紫外-可见光谱研究了混合催化剂的形态和催化性能。使用拉曼光谱和X射线衍射证实了GO成功还原为rGO。微波辐照混合催化剂的出色性能为废水处理以及光催化被认为不可行的高污染废水条件提供了一种可行的低能耗、低碳足迹的新工艺和新型催化剂。