CSIRO (Commonwealth Scientific and Industrial Research Organisation) Manufacturing, 75 Pigdons Road, Waurn Ponds, Geelong, VIC 3216, Australia.
CSIRO (Commonwealth Scientific and Industrial Research Organisation) Data61, 20 Research Way, Clayton, Melbourne, VIC 3168, Australia.
Int J Environ Res Public Health. 2022 Apr 21;19(9):5032. doi: 10.3390/ijerph19095032.
Certified disposable respirators afford important protection from hazardous aerosols but lose performance as they are worn. This study examines the effect of wear time on filtration efficiency. Disposable respirators were worn by CSIRO staff over a period of 4 weeks in early 2020. Participants wore the respirator masks for given times up to eight hours whilst working in laboratory/office environments. At that time COVID-19 precautions required staff to wear surgical (or other) masks and increase use of hand sanitizer from dispenser stations. Results obtained from a test group of ten individuals without health preconditions show an increasing number of masks failing with wear time, while the remainder continue to perform nearly unaffected for up to 8 h. Some masks were found to retain filtration performance better than others, possibly due to the type of challenge they were subjected to by the wearer. However, the rate and extent of decay are expected to differ between environments since there are many contributing factors and properties of the aerosol challenge cannot be controlled in a live trial. Penetration and variability increased during wear; the longer the wear time, the more deleterious to particle removal, particularly after approximately 2 h of wear. This behavior is captured in a descriptive statistical model based on results from a trial with this test group. The effectiveness of the masks in preventing the penetration of KCl particles was determined before and after wearing, with the analysis focusing on the most penetrating particles in a size range of 0.3-0.5 µm diameter where respirator masks are most vulnerable. The basic elements of the study, including the approach to filter testing and sample sanitization, are broadly applicable. Conclusions also have applicability to typical commercially available single-use respirator masks manufactured from melt blown polypropylene as they are reliant on the same physical principles for particle capture and electrostatic enhancement was comparable for the particle size range used for detection.
一次性认证口罩能为人们提供针对有害气溶胶的重要防护,但随着使用时间的增加,其性能会逐渐下降。本研究考察了佩戴时间对过滤效率的影响。2020 年初,CSIRO 的工作人员佩戴一次性口罩,持续佩戴四周。参与者在实验室/办公室环境中工作时,按规定时间佩戴口罩,最长可达 8 小时。当时,为防范 COVID-19,工作人员需要佩戴手术(或其他)口罩,并增加使用从分配站提供的洗手液。从没有健康问题的十名个体组成的测试组获得的结果表明,随着佩戴时间的增加,越来越多的口罩失效,而其余口罩在长达 8 小时的时间内几乎不受影响。一些口罩被发现比其他口罩保持更好的过滤性能,这可能是由于佩戴者对口罩的类型造成的不同挑战。然而,由于环境中有许多因素,气溶胶的挑战的性质无法在现场试验中得到控制,因此衰减的速度和程度预计会因环境而异。渗透和可变性在佩戴过程中增加;佩戴时间越长,对颗粒物去除的危害性越大,特别是佩戴 2 小时后。这种行为是在基于该测试组的试验结果的描述性统计模型中捕获的。在佩戴前后,通过分析最易穿透的颗粒物在 0.3-0.5µm 直径范围内的大小范围,确定了口罩防止 KCl 颗粒渗透的有效性,该范围是口罩最脆弱的区域。研究的基本要素,包括过滤测试和样本消毒的方法,具有广泛的适用性。研究结论也适用于典型的商业上可获得的由熔喷聚丙烯制成的一次性使用口罩,因为它们依赖于相同的物理原理进行颗粒捕获,并且检测到的粒径范围内的静电增强效果相当。