String Gabrielle M, Kamal Yarmina, Gute David M, Lantagne Daniele S
Lancon Environmental LLC, Cambridge, Massachusetts, USA.
Department of Civil and Environmental Engineering, Tufts University, Medford, Massachusetts, USA.
J Environ Sci Health A Tox Hazard Subst Environ Eng. 2022;57(8):685-693. doi: 10.1080/10934529.2022.2101845. Epub 2022 Aug 1.
While efficacy of chlorine against Phi6, a widely-used surrogate for pathogenic enveloped viruses, is well-documented, surfaces common to low-resource contexts are under-researched. We evaluated seven surfaces (stainless steel, plastic, nitrile, tarp, cloth, concrete, wood) and three environmental conditions-temperature (4, 25, 40 °C), relative humidity (RH) (23, 85%), and soiling-to determine Phi6 recoverability and the efficacy of disinfection with 0.5% NaOCl. Overall, Phi6 recovery was >4 log PFU/mL on most surfaces after drying 1 hour at all temperature/humidity conditions. After disinfection, all non-porous test conditions (48/48) achieved ≥4 LRV at 1 and 5 minutes of exposure; significantly more non-porous surfaces met ≥4 LRV than porous ( < 0.001). Comparing porous surfaces, significantly fewer wood samples met ≥4 LRV than cloth ( < 0.001); no differences were observed between concrete and either wood ( = 0.083) or cloth ( = 0.087). Lastly, no differences were observed between soil and no-soil conditions for all surfaces ( = 0.712). This study highlights infectious Phi6 is recoverable across a range of surfaces and environmental conditions, and confirms the efficacy of chlorine disinfection. We recommend treating all surfaces with suspect contamination as potentially infectious, and disinfecting with 0.5% NaOCl for the minimum contact time required for the target enveloped virus (e.g. Ebola, SARS-CoV-2).
虽然氯对Phi6(一种广泛使用的致病性包膜病毒替代物)的有效性已有充分记录,但资源匮乏环境中常见的表面研究不足。我们评估了七种表面(不锈钢、塑料、丁腈、防水油布、布料、混凝土、木材)和三种环境条件——温度(4、25、40°C)、相对湿度(RH)(23、85%)以及污染程度——以确定Phi6的可恢复性和0.5%次氯酸钠消毒的效果。总体而言,在所有温度/湿度条件下干燥1小时后,大多数表面上Phi6的回收率>4 log PFU/mL。消毒后,所有无孔测试条件(48/48)在暴露1分钟和5分钟时达到了≥4个对数减少值(LRV);达到≥4个LRV的无孔表面明显多于多孔表面(<0.001)。比较多孔表面,达到≥4个LRV的木材样本明显少于布料(<0.001);混凝土与木材(=0.083)或布料(=0.087)之间未观察到差异。最后,所有表面在有污染和无污染条件之间未观察到差异(=0.712)。本研究强调,在一系列表面和环境条件下都可检测到具有传染性的Phi6,并证实了氯消毒的有效性。我们建议将所有疑似受污染的表面视为可能具有传染性,并使用0.5%次氯酸钠进行消毒,消毒时间为目标包膜病毒(如埃博拉病毒、SARS-CoV-2)所需的最短接触时间。