Phakkhawan Authit, Sakulkalavek Aparporn, Buranurak Siritorn, Klangtakai Pawinee, Pangza Karnwalee, Jangsawang Nongnuch, Nasompag Sawinee, Horprathum Mati, Kijamnajsuk Suphakan, Sanorpim Sakuntam
Department of Physics, Faculty of Science, King Mongkut's Institute of Technology Ladkrabang, Bangkok 10520, Thailand.
Department of Physics, Faculty of Science, Khon Kaen University, Khon Kaen 40002, Thailand.
Materials (Basel). 2022 Aug 26;15(17):5897. doi: 10.3390/ma15175897.
A systematic investigation of the changes in structural and optical properties of a semi-insulating GaAs (001) wafer under high-energy electron irradiation is presented in this study. GaAs wafers were exposed to high-energy electron beams under different energies of 10, 15, and 20 MeV for absorbed doses ranging from 0-2.0 MGy. The study showed high-energy electron bombardments caused roughening on the surface of the irradiated GaAs samples. At the maximum delivered energy of 20 MeV electrons, the observed root mean square (RMS) roughness increased from 5.993 (0.0 MGy) to 14.944 nm (2.0 MGy). The increased RMS roughness with radiation doses was consistent with an increased hole size of incident electrons on the GaAs surface from 0.015 (0.5 MGy) to 0.066 nm (2.0 MGy) at 20 MeV electrons. Interestingly, roughness on the surface of irradiated GaAs samples affected an increase in material wettability. The study also observed the changes in bandgap energy of GaAs samples after irradiation with 10, 15, and 20 MeV electrons. The band gap energy was found in the 1.364 to 1.397 eV range, and the observed intense UV-VIS spectra were higher than in non-irradiated samples. The results revealed an increase of light absorption in irradiated GaAs samples to be higher than in original-based samples.
本研究对高能电子辐照下半绝缘砷化镓(001)晶片的结构和光学性质变化进行了系统研究。将砷化镓晶片置于能量分别为10、15和20 MeV的高能电子束下,吸收剂量范围为0 - 2.0 MGy。研究表明,高能电子轰击导致辐照后的砷化镓样品表面粗糙化。在20 MeV电子的最大传递能量下,观察到的均方根(RMS)粗糙度从5.993(0.0 MGy)增加到14.944 nm(2.0 MGy)。RMS粗糙度随辐射剂量的增加与20 MeV电子作用下砷化镓表面入射电子空穴尺寸从0.015(0.5 MGy)增加到0.066 nm(2.0 MGy)一致。有趣的是,辐照后的砷化镓样品表面粗糙度影响了材料润湿性的增加。该研究还观察了用10、15和20 MeV电子辐照后砷化镓样品的带隙能量变化。发现带隙能量在1.364至1.397 eV范围内,观察到的强烈紫外 - 可见光谱高于未辐照样品。结果表明,辐照后的砷化镓样品的光吸收增加高于原始样品。