Djas Małgorzata, Matuszewska Anna, Borowa Beata, Kowiorski Krystian, Wieczorek Piotr, Małek Marcin, Chlanda Adrian
Łukasiewicz Research Network-Institute of Microelectronics and Photonics, al. Lotników 32/46, 02-668 Warsaw, Poland.
Faculty of Chemical and Process Engineering, Warsaw University of Technology, Waryńskiego 1, 02-645 Warsaw, Poland.
Materials (Basel). 2022 Nov 4;15(21):7775. doi: 10.3390/ma15217775.
The paper presents the results of research on the use of flake graphene as an additive to plastic grease in order to improve its tribological properties. The influence of concentration (0.25-5.00 wt.%) and the form of graphene (graphene oxide, reduced graphene oxide) on selected properties of the base grease were investigated. It has been found that the addition of graphene flakes improves the anti-wear properties of the lubricant. The greatest improvement in the properties of the lubricant was achieved by using graphene at a concentration of 4.00 wt.%; the reduction in the average diameter of the wear scar was almost 70% for GO and RGO, compared to the base lubricant without the addition of graphene.
本文介绍了关于使用片状石墨烯作为塑料润滑脂添加剂以改善其摩擦学性能的研究结果。研究了浓度(0.25 - 5.00重量%)和石墨烯形式(氧化石墨烯、还原氧化石墨烯)对基础润滑脂选定性能的影响。已发现添加石墨烯片可改善润滑剂的抗磨性能。使用浓度为4.00重量%的石墨烯时,润滑剂性能得到最大程度改善;与未添加石墨烯的基础润滑剂相比,氧化石墨烯和还原氧化石墨烯的磨损斑平均直径减小了近70%。