Jiangxi Yuhongjin Material Technology Co., Ltd., Fuzhou 344100, China.
Department of Physics, School of Science, Jimei University, Xiamen 361021, China.
Molecules. 2022 Nov 5;27(21):7596. doi: 10.3390/molecules27217596.
This paper reports an AlGaN-based ultraviolet-B light-emitting diode (UVB-LED) with a peak wavelength at 293 nm that was almost free of efficiency droop in the temperature range from 298 to 358 K. Its maximum external quantum efficiencies (EQEs), which were measured at a current density of 88.6 A cm, when operated at 298, 318, and 338 K were 2.93, 2.84, and 2.76%, respectively; notably, however, the current droop (J-droop) in each of these cases was less than 1%. When the temperature was 358 K, the maximum EQE of 2.61% occurred at a current density of 63.3 A cm, and the J-droop was 1.52%. We believe that the main mechanism responsible for overcoming the J-droop was the uniform distribution of the concentrations of injected electrons and holes within the multiple quantum wells. Through the subtle design of the p-type AlGaN layer, with the optimization of the composition and doping level, the hole injection efficiency was enhanced, and the Auger recombination mechanism was inhibited in an experimental setting.
本文报道了一种基于 AlGaN 的紫外-B 发光二极管(UVB-LED),其峰值波长为 293nm,在 298 至 358K 的温度范围内几乎没有效率下降。当电流密度为 88.6A/cm 时,在 298、318 和 338K 下测量的最大外量子效率(EQE)分别为 2.93、2.84 和 2.76%;然而,值得注意的是,在这些情况下的电流下降(J-下降)都小于 1%。当温度为 358K 时,在电流密度为 63.3A/cm 时,最大 EQE 为 2.61%,J-下降为 1.52%。我们认为克服 J-下降的主要机制是在多量子阱中注入电子和空穴的浓度均匀分布。通过对 p 型 AlGaN 层进行细微的设计,优化其组成和掺杂水平,提高了空穴注入效率,并在实验中抑制了俄歇复合机制。