Suppr超能文献

利用海藻石莼生物合成铜纳米颗粒及其体外抗氧化潜力

Biosynthesis of Copper Nanoparticles From Seaweed Ulva lactuca and Their In Vitro Antioxidative Potential.

作者信息

S B Shanmugam, Pitchiah Sivaperumal, Suresh Vasugi, Ramasamy Pasiyappazham

机构信息

Department of Physiology, Saveetha Dental College & Hospitals, Saveetha Institute of Medical and Technical Sciences, Saveetha University, Chennai, IND.

Department of Prosthodontics, Saveetha Dental College & Hospitals, Saveetha Institute of Medical and Technical Sciences, Saveetha University, Chennai, IND.

出版信息

Cureus. 2023 Nov 18;15(11):e48985. doi: 10.7759/cureus.48985. eCollection 2023 Nov.

Abstract

BACKGROUND

Marine macroalgae is consumed by individuals in several regions, including Scandinavia, Great Britain, Ireland, China, and Japan; in Japan, it is commonly referred to as aosa. Copper nanoparticles are primarily composed of copper and exhibit a size distribution ranging from 1 to 100 nm. Copper nanoparticles can be synthesized using chemical or natural means, similar to other nanoparticle variants. The nanoparticles in question have garnered significant attention owing to their historical utilization as coloring agents, as well as their contemporary applicability in medicine and antibacterial treatments.

OBJECTIVES

The objective of this study was to investigate the biosynthesis of copper nanoparticles derived from seaweed and explore their in vitro antioxidative potential.

MATERIALS AND METHODS

Seaweed samples (10 g) were mixed with 50 ml of distilled water and placed in a shaker for two days. Copper sulfate (10 mM) was mixed with 100 ml of distilled water to obtain a copper (Cu) solution. Cu nanoparticles were then synthesized by adding the aqueous extract to 100 ml of the Cu solution and mixing it in an orbital shaker at 180 rpm for 24 hours. They were observed both visually and via ultraviolet (UV) spectrophotometry to confirm their nanoparticle synthesis. The initial reading was performed using a UV-visible spectrometer at 300-800 nm. The sample was centrifuged at approximately 8000 rpm for 15 minutes, the pellet was removed, and the pellet was dried in a hot-air oven. The synthesized Cu nanoparticles were then investigated using in vitro antioxidant assays.

RESULT

The seaweed-derived copper nanoparticles exhibited a 1.2 peak absorbance at 580 nm. Various concentrations of copper nanoparticles (25, 50, 75, and 100 µg/ml) were tested for free radical scavenging. As the copper nanoparticle concentration increased, the scavenging ability on 1, 1-diphenyl-2-picrylhydrazyl (DPPH) radicals assay showed that the free radical scavenging activity increased in a dose-dependent manner. Similar to the DPPH assay, the total antioxidant and hydrogen peroxide (HO)assays showed increased free radical scavenging with increasing concentration.

CONCLUSION

The application of Cu nanoparticles in the synthesis process has the potential to enhance the antioxidant activity of as evidenced by the observed increase in antioxidant capacity and defense against reactive oxygen species.

摘要

背景

包括斯堪的纳维亚、英国、爱尔兰、中国和日本在内的多个地区的人们都会食用大型海藻;在日本,大型海藻通常被称为“aosa”。铜纳米颗粒主要由铜组成,粒径分布在1至100纳米之间。与其他纳米颗粒变体类似,铜纳米颗粒可以通过化学或自然方法合成。鉴于其作为着色剂的历史用途以及在医学和抗菌治疗中的当代应用,这些纳米颗粒受到了广泛关注。

目的

本研究旨在探究源自海藻的铜纳米颗粒的生物合成,并探索其体外抗氧化潜力。

材料与方法

将海藻样品(10克)与50毫升蒸馏水混合,置于振荡器中振荡两天。将硫酸铜(10毫摩尔)与100毫升蒸馏水混合以获得铜(Cu)溶液。然后,通过将水提取物加入100毫升铜溶液中,并在轨道振荡器中以180转/分钟的速度混合24小时来合成铜纳米颗粒。通过肉眼观察和紫外(UV)分光光度法确认纳米颗粒的合成。初始读数使用紫外可见光谱仪在300 - 800纳米范围内进行。样品以约8000转/分钟的速度离心15分钟,去除沉淀,并将沉淀在热风烘箱中干燥。然后使用体外抗氧化试验对合成的铜纳米颗粒进行研究。

结果

源自海藻的铜纳米颗粒在580纳米处呈现1.2的吸光度峰值。测试了不同浓度(25、50、75和一百微克/毫升)的铜纳米颗粒对自由基的清除能力。随着铜纳米颗粒浓度的增加,1,1 - 二苯基 - 2 - 苦基肼(DPPH)自由基清除试验表明自由基清除活性呈剂量依赖性增加。与DPPH试验类似,总抗氧化能力和过氧化氢(H₂O₂)试验表明随着浓度增加自由基清除能力增强。

结论

正如观察到的抗氧化能力增强和对活性氧的防御能力提升所证明的那样,铜纳米颗粒在合成过程中的应用有可能增强海藻的抗氧化活性。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/9fff/10726088/87a9fd2f1a4f/cureus-0015-00000048985-i01.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验