Benz L, Heck K, Hevisov D, Kugelmann D, Tseng P-C, Sreij Z, Litzenburger F, Waschke J, Schwendicke F, Kienle A, Hickel R, Kunzelmann K-H, Walter E
Department of Conservative Dentistry and Periodontology, LMU Hospital, LMU, Munich, Germany.
Institut für Lasertechnologien in der Medizin und Meßtechnik an der Universität Ulm, Ulm, Germany.
J Dent Res. 2024 Dec;103(13):1375-1383. doi: 10.1177/00220345241262949. Epub 2024 Aug 5.
Endodontic access preparation is one of the initial steps in root canal treatments and can be hindered by the obliteration of pulp canals and formation of tertiary dentin. Until now, methods for direct intraoperative visualization of the 3-dimensional anatomy of teeth have been missing. Here, we evaluate the use of shortwave infrared radiation (SWIR) for navigation during stepwise access preparation. Nine teeth (3 anteriors, 3 premolars, and 3 molars) were explanted with intact periodontium including alveolar bone and mucosa from the upper or lower jaw of human body donors. Analysis was performed at baseline as well as at preparation depths of 5 mm, 7 mm, and 9 mm, respectively. For reflection, SWIR was used at a wavelength of 1,550 nm from the occlusal direction, whereas for transillumination, SWIR was passed through each sample at the marginal gingiva from the buccal as well as oral side at a wavelength of 1,300 nm. Pulpal structures could be identified as darker areas approximately 2 mm before reaching the pulp chamber using SWIR transillumination, although they were indistinguishable under normal circumstances. Furcation areas in molars appeared with higher intensity than areas with canals. The location of pulpal structures was confirmed by superimposition of segmented micro-computed tomography (µCT) images. By radiomic analysis, significant differences between pulpal and parapulpal areas could be detected in image features. With hierarchical cluster analysis, both segments could be confirmed and associated with specific clusters. The local thickness of µCTs was calculated and correlated with SWIR transillumination images, by which a linear dependency of thickness and intensity could be demonstrated. Lastly, by simulations of light propagation, dentin tubules were shown to be a crucial factor for understanding the visibility of the pulp. In conclusion, SWIR transillumination may allow direct clinical live navigation during endodontic access preparation.
牙髓腔通路预备是根管治疗的初始步骤之一,可能会受到牙髓腔闭塞和第三期牙本质形成的阻碍。到目前为止,一直缺少术中直接可视化牙齿三维解剖结构的方法。在此,我们评估短波红外辐射(SWIR)在逐步进行通路预备过程中的导航应用。从人体捐献者的上颌或下颌中取出9颗牙齿(3颗前牙、3颗前磨牙和3颗磨牙),保留完整的牙周组织,包括牙槽骨和黏膜。分别在基线以及预备深度为5毫米、7毫米和9毫米时进行分析。对于反射,从咬合方向使用波长为1550纳米的SWIR,而对于透照,在边缘龈处从颊侧和舌侧以波长1300纳米使SWIR穿过每个样本。使用SWIR透照时,在到达髓腔前约2毫米处,牙髓结构可被识别为较暗区域,尽管在正常情况下它们难以区分。磨牙的根分叉区域比有根管的区域显示出更高的强度。通过叠加分割的显微计算机断层扫描(µCT)图像确认了牙髓结构的位置。通过放射组学分析,在图像特征中可检测到牙髓和牙髓旁区域之间的显著差异。通过层次聚类分析,两个部分均可得到确认并与特定聚类相关联。计算了µCT的局部厚度并将其与SWIR透照图像相关联,由此可证明厚度与强度之间存在线性相关性。最后,通过光传播模拟,表明牙本质小管是理解牙髓可见性的关键因素。总之,SWIR透照可能允许在牙髓腔通路预备过程中进行直接临床实时导航。