Filippou Antria, Evripidou Nikolas, Georgiou Andreas, Nikolaou Anastasia, Damianou Christakis
Department of Electrical Engineering, Computer Engineering and Informatics, Cyprus University of Technology, Limassol, Cyprus.
J Med Phys. 2024 Apr-Jun;49(2):167-180. doi: 10.4103/jmp.jmp_146_23. Epub 2024 Jun 25.
Agar-based phantoms are popular in high intensity focused ultrasound (HIFU) studies, with magnetic resonance imaging (MRI) preferred for guidance since it provides temperature monitoring by proton resonance frequency (PRF) shift magnetic resonance (MR) thermometry. MR thermometry monitoring depends on several factors, thus, herein, the PRF coefficient of agar phantoms was estimated.
Seven phantoms were developed with varied agar (2, 4, or 6% w/v) or constant agar (6% w/v) and varied silica concentrations (2, 4, 6, or 8% w/v) to assess the effect of the concentration on the PRF coefficient. Each phantom was sonicated using varied acoustical power for a 30 s duration in both a laboratory setting and inside a 3T MRI scanner. PRF coefficients were estimated through linear trends between phase shift acquired using gradient sequences and thermocouple-based temperatures changes.
Linear regression ( = 0.9707-0.9991) demonstrated a proportional dependency of phase shift with temperature change, resulting in PRF coefficients between -0.00336 ± 0.00029 and -0.00934 ± 0.00050 ppm/°C for the various phantom recipes. Weak negative linear correlations of the PRF coefficient were observed with increased agar. With silica concentrations, the negative linear correlation was strong. For all phantoms, calibrated PRF coefficients resulted in 1.01-3.01-fold higher temperature changes compared to the values calculated using a literature PRF coefficient.
Phantoms developed with a 6% w/v agar concentration and doped with 0%-8% w/v silica best resemble tissue PRF coefficients and should be preferred in HIFU studies. The estimated PRF coefficients can result in enhanced MR thermometry monitoring and evaluation of HIFU protocols.
基于琼脂的体模在高强度聚焦超声(HIFU)研究中很受欢迎,由于磁共振成像(MRI)能通过质子共振频率(PRF)位移磁共振(MR)测温法进行温度监测,因此常被选作引导手段。MR测温监测取决于多个因素,所以在此对琼脂体模的PRF系数进行了估算。
制备了七个体模,其中琼脂浓度不同(2%、4%或6% w/v)或琼脂浓度恒定(6% w/v)且二氧化硅浓度不同(2%、4%、6%或8% w/v),以评估浓度对PRF系数的影响。在实验室环境和3T MRI扫描仪内,使用不同的声功率对每个体模进行30秒的超声处理。通过使用梯度序列获取的相移与基于热电偶的温度变化之间的线性趋势来估算PRF系数。
线性回归( = 0.9707 - 0.9991)表明相移与温度变化呈比例依赖关系,不同体模配方的PRF系数在-0.00336 ± 0.00029至-0.00934 ± 0.00050 ppm/°C之间。随着琼脂含量增加,观察到PRF系数呈弱负线性相关。对于二氧化硅浓度,负线性相关性很强。对于所有体模,校准后的PRF系数导致的温度变化比使用文献PRF系数计算的值高1.01 - 3.01倍。
含6% w/v琼脂浓度并掺杂0% - 8% w/v二氧化硅的体模最接近组织PRF系数,在HIFU研究中应优先选用。估算的PRF系数可增强MR测温监测及HIFU方案的评估。