Comparative Analysis of Electrophoretic Deposition and Dip Coating for Enhancing Electrical Properties of Electrospun PVDF Mats Through Carbon Nanotube Deposition.

Integrating carbon nanotubes (CNTs) into electrospun polyvinylidene fluoride (PVDF) fibers is a promising approach for developing conductive and multifunctional materials. This study systematically compared two CNT deposition techniques, electrophoretic deposition (EPD) and dip coating (DC), in terms of their effectiveness in modifying the surface of aligned electrospun PVDF mats. Morphological characterization revealed that EPD produced more homogeneous and compact CNT coatings. In contrast, DC resulted in discontinuous and irregular layers regardless of deposition time. A key distinction between the two methods was the tunability of the coating: EPD allowed for precise control over CNT layer thickness and mass accumulation by adjusting the deposition time. In contrast, DC showed no significant changes in thickness with longer immersion. These structural differences translated into distinct electrical behaviors. Resistance measurements showed that EPD samples exhibited a substantial decrease in resistance with increasing deposition time, from 5.9 ± 2.5 kΩ to 0.2 ± 0.1 kΩ, indicating the formation of well-connected conductive pathways. On the other hand, DC samples maintained relatively constant, higher resistance values across all conditions. Additionally, EPD-coated mats demonstrated enhanced touch sensitivity, generating higher and more stable current responses compared to DC-deposited samples. These results confirm that EPD is a more effective, tunable method for fabricating conductive CNT coatings on electrospun PVDF mats, particularly for applications in flexible electronics and wearable sensors.