Suppr超能文献

利用原子力显微镜研究MDCK单层细胞的表面形态和力学性能

Surface morphology and mechanical properties of MDCK monolayers by atomic force microscopy.

作者信息

Hoh J H, Schoenenberger C A

机构信息

Department of Physics, University of California Santa Barbara 93106.

出版信息

J Cell Sci. 1994 May;107 ( Pt 5):1105-14. doi: 10.1242/jcs.107.5.1105.

Abstract

We describe the morphology and mechanical stability of the apical surface of MDCK monolayers by atomic force microscopy (AFM). Living cells could be imaged in physiological solution for several hours without noticeable deterioration. Cell boundaries appear as ridges that clearly demarcate neighboring cells. In some cases the nucleus of individual cells could be seen, though apparently only in very thin areas of the monolayer. Two types of protrusions on the surface could be visualized. Smooth bulges that varied in width from a few hundred nanometers to several micrometers, which appear to represent relatively rigid subapical structures. Another type of protrusion extended well above the membrane and was swept back and forth during the imaging. However, the microvilli that are typically present on the apical surface could not be resolved. For comparison, a transformed MDCK cell line expressing the K-ras oncogene was also examined. When cultured on solid substrata at low density, the R5 cells spread out and are less than 100 nm thick over large areas with both extensive processes and rounded edges. Many intracellular structures such as the nucleus, cytoskeletal elements and vesicles could be visualized. None of the intracellular structures seen in the AFM images could be seen by scanning electron microscopy. Both R5 cells and MDCK monolayers required imaging forces of > 2 nN for good image contrast. Force measurements on the MDCK monolayers show that they are very soft, with an effective spring constant of approximately 0.002 N/m for the apical plasma membrane, over the first micrometer of deformation, resulting in a height deformation of approximately 500 nm per nanoNewton of applied force. The mechanical properties of the cells could be manipulated by addition of glutaraldehyde. These changes were monitored in real time by collecting force curves during the fixation reaction. The curves show a stiffening of the apical plasma membrane that was completed in approximately 1 minute. On the basis of these measurements and the imaging forces required, we conclude that deformation of the plasma membrane is an important component of the contrast mechanism, in effect 'staining' structures based on their relative rigidity.

摘要

我们通过原子力显微镜(AFM)描述了MDCK单层细胞顶端表面的形态和机械稳定性。活细胞可在生理溶液中成像数小时而无明显恶化。细胞边界表现为清晰划分相邻细胞的脊状结构。在某些情况下,可以看到单个细胞的细胞核,不过显然仅在单层非常薄的区域中。可以观察到表面上有两种类型的突起。光滑的凸起宽度从几百纳米到几微米不等,这似乎代表相对刚性的亚顶端结构。另一种类型的突起在膜上方延伸得很高,并且在成像过程中来回摆动。然而,通常存在于顶端表面的微绒毛无法分辨。作为比较,还检查了表达K-ras癌基因的转化MDCK细胞系。当在固体基质上低密度培养时,R5细胞铺展,在大面积上厚度小于100 nm,具有广泛的突起和圆形边缘。许多细胞内结构如细胞核、细胞骨架元件和囊泡都可以观察到。在AFM图像中看到的细胞内结构,扫描电子显微镜均未观察到。R5细胞和MDCK单层都需要大于2 nN的成像力才能获得良好的图像对比度。对MDCK单层的力测量表明它们非常柔软,在变形的第一微米内,顶端质膜的有效弹簧常数约为0.002 N/m,导致每纳牛顿施加力的高度变形约为500 nm。通过添加戊二醛可以操纵细胞的机械性能。在固定反应过程中通过收集力曲线实时监测这些变化。曲线显示顶端质膜在大约1分钟内变硬。基于这些测量结果和所需的成像力,我们得出结论,质膜的变形是对比度机制的重要组成部分,实际上是根据结构的相对刚性对其进行“染色”。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验