Suppr超能文献

尸僵的实验评估。VIII. 通过对大鼠尸僵强度的重复测量来估计死亡时间

Experimental evaluation of rigor mortis. VIII. Estimation of time since death by repeated measurements of the intensity of rigor mortis on rats.

作者信息

Krompecher T

机构信息

Institut Universitaire de Médecine Légale, Lausanne, Switzerland.

出版信息

Forensic Sci Int. 1994 Oct 21;68(3):149-59. doi: 10.1016/0379-0738(94)90354-9.

Abstract

The development of the intensity of rigor mortis was monitored in nine groups of rats. The measurements were initiated after 2, 4, 5, 6, 8, 12, 15, 24, and 48 h post mortem (p.m.) and lasted 5-9 h, which ideally should correspond to the usual procedure after the discovery of a corpse. The experiments were carried out at an ambient temperature of 24 degrees C. Measurements initiated early after death resulted in curves with a rising portion, a plateau, and a descending slope. Delaying the initial measurement translated into shorter rising portions, and curves initiated 8 h p.m. or later are comprised of a plateau and/or a downward slope only. Three different phases were observed suggesting simple rules that can help estimate the time since death: (1) if an increase in intensity was found, the initial measurements were conducted not later than 5 h p.m.; (2) if only a decrease in intensity was observed, the initial measurements were conducted not earlier than 7 h p.m.; and (3) at 24 h p.m., the resolution is complete, and no further changes in intensity should occur. Our results clearly demonstrate that repeated measurements of the intensity of rigor mortis allow a more accurate estimation of the time since death of the experimental animals than the single measurement method used earlier. A critical review of the literature on the estimation of time since death on the basis of objective measurements of the intensity of rigor mortis is also presented.

摘要

在九组大鼠中监测了尸僵强度的发展情况。测量在死后2、4、5、6、8、12、15、24和48小时开始,持续5 - 9小时,这理想情况下应与发现尸体后的常规程序相对应。实验在24摄氏度的环境温度下进行。死亡后早期开始测量得到的曲线有上升部分、平台期和下降斜率。延迟初始测量会导致上升部分变短,并且在死后8小时或更晚开始的曲线仅由平台期和/或下降斜率组成。观察到三个不同阶段,这表明了一些有助于估计死亡时间的简单规则:(1)如果发现强度增加,初始测量不迟于死后5小时进行;(2)如果仅观察到强度降低,初始测量不早于死后7小时进行;(3)在死后24小时,分解完成,强度不应再发生进一步变化。我们的结果清楚地表明,与早期使用的单次测量方法相比,重复测量尸僵强度能更准确地估计实验动物的死亡时间。本文还对基于客观测量尸僵强度来估计死亡时间的文献进行了批判性综述。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验