Suppr超能文献

在自愿运动过程中,因恒定位置误差而在人体肘关节产生的扭矩。

Torques generated at the human elbow joint in response to constant position errors imposed during voluntary movements.

作者信息

Bennett D J

机构信息

Department of Brain and Cognitive Sciences, Massachusetts Institute of Technology, Cambridge 02139.

出版信息

Exp Brain Res. 1993;95(3):488-98. doi: 10.1007/BF00227142.

Abstract

The stiffness of the human elbow joint was investigated during targeted, 1.0-rad voluntary flexion movements at speeds ranging from slow (1.5 rad/s) to very fast (6.0 rad/s). A torque motor produced controlled step position errors in the execution of the movements. The steps began at the onset of movement, rose to an amplitude of 0.15 rad in 100 ms, and had a duration equal to movement duration. The net joint torque (muscle torque) resisting the step perturbation was computed from the applied torque, the joint acceleration, and the limb inertia. Subjects resisted the imposed step changes with approximately step changes in the net muscle torque. The mean resistance torque divided by the step amplitude was computed and is referred to as the stiffness. The stiffness increased with the voluntary movement speed, over the range of speeds (1.5-6 rad/s). The stiffness increased linearly with the magnitude of the net muscle torque on the unperturbed trials (referred to as "background torque"). The stiffness changed by only 20% when the step amplitude ranged from 0.05 to 0.15 rad. The mechanical resonant frequency (fr), estimated from the average stiffness estimates, ranged from 0.8 to 3.0 Hz. The resonant frequency approximately equaled the principal frequency component of the movement fm. On average: fr = 0.96 fm +0.46. During the fixed, 100-ms rise time of the step, the resistance was not linearly related to the background torque. At slower speeds the resistance was relatively greater during this rise time. However, when the imposed step perturbation was modified so that its rise time occurred in a time proportional to the movement duration (rather than in the fixed, 100-ms, time), the muscle torque resisting the motor during this rise time was proportional to the background torque. When these modified step responses were plotted on a time scale normalized to the movement duration, they all had approximately the same shape. Apparently the muscle viscosity scaled with the stiffness so as to maintain the constant response shape (constant damping ratio). The observed "tuning" of the mechanical properties to the movement speed is suggested to be important in the robust generation of smooth stereotyped voluntary movements.

摘要

在目标性的1.0弧度自主屈曲运动过程中,研究了人体肘关节在从慢速(1.5弧度/秒)到极快速(6.0弧度/秒)的速度范围内的刚度。一个扭矩电机在运动执行过程中产生可控的阶跃位置误差。这些阶跃在运动开始时启动,在100毫秒内上升到0.15弧度的幅度,并且持续时间等于运动持续时间。抵抗阶跃扰动的净关节扭矩(肌肉扭矩)由施加的扭矩、关节加速度和肢体惯性计算得出。受试者通过净肌肉扭矩的近似阶跃变化来抵抗施加的阶跃变化。计算平均抵抗扭矩除以阶跃幅度,并将其称为刚度。在速度范围(1.5 - 6弧度/秒)内,刚度随着自主运动速度的增加而增加。在未受扰动的试验中(称为“背景扭矩”),刚度与净肌肉扭矩的大小呈线性增加。当阶跃幅度在0.05至0.15弧度范围内时,刚度仅变化20%。根据平均刚度估计值估算的机械共振频率(fr)范围为0.8至3.0赫兹。共振频率大致等于运动的主要频率成分fm。平均而言:fr = 0.96fm + 0.46。在阶跃的固定100毫秒上升时间内,阻力与背景扭矩并非线性相关。在较慢速度下,在此上升时间内阻力相对较大。然而,当修改施加的阶跃扰动,使其上升时间与运动持续时间成比例(而不是固定的100毫秒时间)时,在此上升时间内抵抗电机的肌肉扭矩与背景扭矩成比例。当这些修改后的阶跃响应绘制在以运动持续时间归一化的时间尺度上时,它们都具有大致相同的形状。显然肌肉粘性随刚度缩放,以便维持恒定的响应形状(恒定阻尼比)。观察到的机械特性对运动速度的“调谐”被认为在稳健地产生平滑定型的自主运动中很重要。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验