Koutsis G, Philippides A, Huang C L
Physiological Laboratory, Cambridge, UK.
J Muscle Res Cell Motil. 1995 Oct;16(5):519-28. doi: 10.1007/BF00126436.
Rana temporaria sartorius muscle fibres were exposed to varied sequences of solution and temperature changes that have been employed hitherto in procedures that sought to decouple the transverse tubules from the surface membrane. The incidence of such detubulation was assessed in large numbers of fibres through demonstrating a loss or otherwise of the after-depolarization that normally reflects successful tubular propagation of the surface action potential. This criterion yielded assessments of the existing detubulation techniques in agreement with earlier results. The experiments then developed an improved detubulation procedure that required only brief (15 min) exposures to glycerol, its replacement in a single step by a Ca2+/Mg(2+)-Ringer solution for 30 min, and rapid cooling from room temperature (19-21 degrees C) to 6-10 degrees C prior to final restoration of the normal Ringer solution. This sequence of steps yielded an optimal incidence (98%) of detubulation in viable surface fibres that were amenable to electrophysiological studies. Studies that systematically modified the detubulation procedure demonstrated that the omission of any one step in the protocol significantly reduced the incidence of detubulation with or without accompanying deteriorations in fibre resting potentials. Successful detubulation accordingly required an initial exposure to an optimal glycerol concentration that lasted for a minimal duration and for its abrupt withdrawal. Inclusion of a cooling step within 30 min after glycerol withdrawal was coincident with, and critical to, optimal tubular isolation. Thus, cooling steps that either preceded, or that followed the glycerol withdrawal step by more than 60 min, resulted in a sharp reduction in the incidence of detubulation. Similarly, a critical period of exposure to Ca2+/Mg2+ Ringer solution also promoted detubulation without compromising the recovery of stable and satisfactory resting potentials. The findings reported here remain consistent with a primarily osmotic mechanism for detubulation. However, they demonstrated additional and important influences of temperature and of divalent cation concentration on the extent of tubular detachment when such factors were modified during the time course of the expected volume changes that followed each adjustment in osmotic condition.
将林蛙缝匠肌纤维暴露于各种溶液和温度变化序列中,这些序列是迄今为止在试图使横管与表面膜解耦的实验程序中所采用的。通过证明通常反映表面动作电位在管中成功传播的去极化后电位的丧失或其他情况,对大量纤维中这种去管化的发生率进行了评估。该标准得出的对现有去管化技术的评估结果与早期结果一致。然后,实验开发了一种改进的去管化程序,该程序仅需将纤维短暂(15分钟)暴露于甘油中,然后在一步中将其替换为Ca2+/Mg(2+)林格氏液30分钟,并在最终恢复正常林格氏液之前从室温(19-21摄氏度)快速冷却至6-10摄氏度。这一系列步骤在适合电生理研究的存活表面纤维中产生了最佳的去管化发生率(98%)。系统地改变去管化程序的研究表明,方案中省略任何一个步骤都会显著降低去管化的发生率,无论纤维静息电位是否随之恶化。因此,成功的去管化需要最初暴露于最佳甘油浓度下,持续最短时间并突然撤去甘油。在撤去甘油后30分钟内加入冷却步骤与最佳的管分离同时发生且至关重要。因此,在撤去甘油步骤之前或之后超过60分钟进行的冷却步骤会导致去管化发生率急剧降低。同样,暴露于Ca2+/Mg2+林格氏液的关键时期也促进了去管化,而不会影响稳定且令人满意的静息电位的恢复。此处报道的研究结果与去管化主要是渗透机制的观点一致。然而,当在每次渗透压条件调整后预期的体积变化过程中改变温度和二价阳离子浓度等因素时,它们显示出这些因素对管分离程度有额外且重要的影响。