Suppr超能文献

二维与三维肿瘤体积定量测定对当前治疗反应评估方法的影响。

The impact of 2D versus 3D quantitation of tumor bulk determination on current methods of assessing response to treatment.

作者信息

Hopper K D, Kasales C J, Eggli K D, TenHave T R, Belman N M, Potok P S, Van Slyke M A, Olt G J, Close P, Lipton A, Harvey H A, Hartzel J S

机构信息

Department of Radiology, Penn State University, Hershey 17033, USA.

出版信息

J Comput Assist Tomogr. 1996 Nov-Dec;20(6):930-7. doi: 10.1097/00004728-199611000-00011.

Abstract

PURPOSE

Measurements from sequential axial "2D" data in cancer patients are commonly used to assess treatment response or disease progression. This study compares the volume of tumor bulk calculated with 3D reconstructions with that calculated by conventional methods to determine if it might change patient classification.

METHOD

All medical, gynecologic, and pediatric oncology patients under treatment who were evaluated with serial CT scans between January 1, 1992, and July 31, 1994, for whom the digital data were available were included in this study. For each tumor site, the maximum diameter and its perpendicular were measured and multiplied together to yield an area. The sum of areas of the measured lesions was used as an approximation of overall 2D tumor volume. In addition, the 2D area of each site was multiplied by its height, yielding a 2D volume. Last, the digital data were loaded into a 3D computer system and total 3D tumor volumes determined. All medical and gynecologic oncology patients were treated based upon the 2D area of tumor. The pediatric oncology patients were treated based upon the 2D volume of tumor measured as per standard practice. The members of each treating oncologic service assessed their patients as to how the other two methods would have changed their classification of the patients' response category.

RESULTS

Four hundred thirty-three CT scans were performed in 139 patients, which included 204 baseline and 294 follow-up CT examinations. Seventy patients had new tumor foci and would have been classified as failure by all three methods of tumor bulk measurement. The 3D volume versus the 2D area method of tumor bulk assessment would have changed response categories in 52 of the 294 follow-up CT examinations (p < 0.0001). Thirty-five patients were recategorized from either "no response" to "failure" (21 patients) or "no response" to "response" (14 patients) categories. If only those follow-up studies without new metastatic foci are considered, the 3D volume versus the 2D area methods of tumor assessment would have changed the treatment response category in 23.2%. The use of the 2D volume method of calculating tumor volume of bulk tended to overestimate the overall tumor size by an average of 244 cm3 (p = 0.001).

CONCLUSION

The 3D method of tumor volume measurement differs significantly from conventional 2D methods of tumor volume determination. Large prospective studies analyzing the usefulness of 3D tumor volume measurements and assessing possible changes in patient response categories would be required for full utilization of this more accurate method of following disease bulk.

摘要

目的

癌症患者连续轴向“二维”数据的测量常用于评估治疗反应或疾病进展。本研究比较了通过三维重建计算的肿瘤总体积与传统方法计算的体积,以确定其是否可能改变患者的分类。

方法

本研究纳入了1992年1月1日至1994年7月31日期间接受系列CT扫描评估且有数字数据的所有正在接受治疗的医学、妇科和儿科肿瘤患者。对于每个肿瘤部位,测量其最大直径及其垂直直径并相乘得出面积。所测病变面积之和用作二维肿瘤总体积的近似值。此外,每个部位的二维面积乘以其高度,得出二维体积。最后,将数字数据加载到三维计算机系统中并确定肿瘤总体积。所有医学和妇科肿瘤患者均根据肿瘤的二维面积进行治疗。儿科肿瘤患者根据按照标准做法测量的肿瘤二维体积进行治疗。每个治疗肿瘤科室的成员评估其患者,看另外两种方法会如何改变他们对患者反应类别的分类。

结果

139例患者共进行了433次CT扫描,其中包括204次基线CT检查和294次随访CT检查。70例患者有新的肿瘤病灶,这三种肿瘤体积测量方法均会将其归类为治疗失败。在294次随访CT检查中,三维体积与二维面积肿瘤体积评估方法会改变反应类别52次(p < 0.0001)。35例患者被重新分类,其中21例从“无反应”重新分类为“治疗失败”,14例从“无反应”重新分类为“有反应”。如果仅考虑那些没有新转移灶的随访研究,三维体积与二维面积肿瘤评估方法会改变23.2%的治疗反应类别。使用二维体积法计算肿瘤总体积往往会高估总体肿瘤大小,平均高估244 cm³(p = 0.001)。

结论

肿瘤体积测量的三维方法与传统的二维肿瘤体积测定方法有显著差异。要充分利用这种更准确的跟踪疾病大小的方法,需要进行大型前瞻性研究,分析三维肿瘤体积测量的实用性并评估患者反应类别可能的变化。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验