Liu Xiaoguang, Zhu Ying, Yang Shang-Tian
Department of Chemical and Biomolecular Engineering, The Ohio State University, 140 West 19th Avenue, Columbus, Ohio 43210, USA.
Biotechnol Prog. 2006 Sep-Oct;22(5):1265-75. doi: 10.1021/bp060082g.
Clostridium tyrobutyricum produces butyrate, acetate, H(2), and CO(2) as its main fermentation products from glucose and xylose. To improve butyric acid and hydrogen production, integrational mutagenesis was used to create a metabolically engineered mutant with inactivated ack gene, encoding acetate kinase (AK) associated with the acetate formation pathway. A non-replicative plasmid containing the acetate kinase gene (ack) fragment was constructed and introduced into C. tyrobutyricum by electroporation. Integration of the plasmid into the homologous region on the chromosome should inactivate the target ack gene and produce ack-deleted mutant, PAK-Em. Enzyme activity assays showed that the AK activity in PAK-Em decreased by approximately 50%; meanwhile, phosphotransacetylase (PTA) and hydrogenase activities each increased by approximately 40%. The sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) results showed that the expression of protein with approximately 32 kDa molecular mass was reduced significantly in the mutant. Compared to the wild type, the mutant grew more slowly at pH 6.0 and 37 degrees C, with a lower specific growth rate of 0.14 h(-1) (vs 0.21 h(-1) for the wild type), likely due to the partially impaired PTA-AK pathway. However, the mutant produced 23.5% more butyrate (0.42 vs 0.34 g/g glucose) at a higher final concentration of 41.7 g/L (vs 19.98 g/L) as a result of its higher butyrate tolerance as indicated in the growth kinetics study using various intial concentrations of butyrate in the media. The mutant also produced 50% more hydrogen (0.024 g/g) from glucose than the wild type. Immobilized-cell fermentation of PAK-Em in a fibrous-bed bioreactor (FBB) further increased the final butyric acid concentration (50.1 g/L) and the butyrate yield (0.45 g/g glucose). Furthermore, in the FBB fermentation at pH 5.0 with xylose as the substrate, only butyric acid was produced by the mutant, whereas the wild type produced large amounts of acetate (0.43 g/g xylose) and lactate (0.61 g/g xylose) and little butyrate (0.05 g/g xylose), indicating a dramatic metabolic pathway shift caused by the ack deletion in the mutant.
酪丁酸梭菌以葡萄糖和木糖为底物进行发酵,主要产物为丁酸、乙酸、氢气和二氧化碳。为提高丁酸和氢气产量,采用整合诱变技术构建了一个代谢工程突变体,该突变体的ack基因失活,ack基因编码与乙酸生成途径相关的乙酸激酶(AK)。构建了一个含有乙酸激酶基因(ack)片段的非复制性质粒,并通过电穿孔法将其导入酪丁酸梭菌。质粒整合到染色体上的同源区域会使目标ack基因失活,从而产生ack基因缺失的突变体PAK-Em。酶活性测定表明,PAK-Em中的AK活性降低了约50%;同时,磷酸转乙酰酶(PTA)和氢化酶活性分别提高了约40%。十二烷基硫酸钠-聚丙烯酰胺凝胶电泳(SDS-PAGE)结果表明,突变体中分子量约为32 kDa的蛋白质表达显著降低。与野生型相比,突变体在pH 6.0和37℃条件下生长较慢,比生长速率较低,为0.14 h⁻¹(野生型为0.21 h⁻¹),这可能是由于PTA-AK途径部分受损所致。然而,在使用不同初始丁酸浓度的培养基进行生长动力学研究中发现,突变体对丁酸的耐受性较高,因此其丁酸产量更高,终浓度达到41.7 g/L(野生型为19.98 g/L),比野生型多产23.5%的丁酸(0.42 g/g葡萄糖 vs 0.34 g/g葡萄糖)。突变体从葡萄糖中产生的氢气也比野生型多50%(0.024 g/g)。在纤维床生物反应器(FBB)中对PAK-Em进行固定化细胞发酵,进一步提高了丁酸终浓度(50.1 g/L)和丁酸产量(0.45 g/g葡萄糖)。此外,在以木糖为底物、pH 5.0的FBB发酵中,突变体只产生丁酸,而野生型则产生大量乙酸(0.43 g/g木糖)和乳酸(0.61 g/g木糖),产生的丁酸很少(0.05 g/g木糖),这表明突变体中ack基因的缺失导致了代谢途径的显著转变。