Histomorphometric analysis of the osseointegration of four different implant surfaces in the femoral epiphyses of rabbits.

OBJECTIVES

The surface properties of titanium dental implants are key parameters for rapid and intimate bone-implant contact. The osseointegration of four implant surfaces was studied in the femoral epiphyses of rabbits.

MATERIAL AND METHODS

Titanium implants were either grit-blasted with alumina or biphasic calcium phosphate (BCP) ceramic particles, coated with a thin octacalcium phosphate (OCP) layer, or prepared by large-grit sand blasting and acid-etched (SLA). After 2 and 8 weeks of implantation, the bone-implant contact and bone growth inside the chambers were compared. Scanning electron microscopy (SEM) and profilometry showed distinct microtopographies.

RESULTS

The alumina-Ti, BCP-Ti and OCP-Ti groups had similar average surface roughness in the 1-2 mum range whereas the SLA surface was significantly higher with a roughness averaging 4.5 microm. Concerning the osseointegration, the study demonstrated a significantly greater bone-to-implant contact for both the SLA and OCP-Ti surfaces as compared with the grit-blasted surfaces, alumina- and BCP-Ti at both 2 and 8 weeks of healing.

CONCLUSION

In this animal model, a biomimetic calcium phosphate coating gave similar osseointegration to the SLA surface. This biomimetic coating method may enhance the apposition of bone onto titanium dental implants.