Martos J, Ferrer-Luque C M, González-Rodríguez M P, Castro L A S
Department of Semiology and Clinics, School of Dentistry, Federal University of Pelotas, RS, Brazil.
Int Endod J. 2009 Apr;42(4):329-34. doi: 10.1111/j.1365-2591.2008.01513.x. Epub 2009 Feb 7.
To determine the distance from the anatomical root apex to the major apical foramen and the position of the major foramen on the root apex.
Crowns of 926 human teeth were sectioned at the cementum-enamel junction. Specimens were mounted on microscope slides for measurement parallel to the long axis of the teeth. The major foramen was identified as the largest-diameter opening at the root apex. A total of 1331 root specimens were evaluated using an optical stereomicroscope to an accuracy of 0.01 mm at 40 x (+/-10) magnification. The distance from the anatomical apex to the most apical point of the major foramen was measured, and its location (central, buccal, lingual, mesial and distal) was recorded.
The mean distance between the major foramen and the anatomical root apex was 0.69 mm; the mean distance was larger in posterior teeth (0.82 mm) and smaller in anterior teeth (0.39 mm). A wide range of anatomical apex to major foramen distances were observed in all tooth groups: the greatest distance was in maxillary molars (0.95 mm) followed by mandibular pre-molars (0.87 mm) and mandibular molars (0.80 mm). The major foramen was at the tip of the root in 40% of teeth. The most frequent deviations of the foramen were to the buccal (20%) and distal (14%).
In this sample of teeth without apical resorption the distance between the major foramen and the anatomical root apex was always <1 mm. Deviation of the major foramen from the anatomic apex varied widely amongst tooth groups.
确定从解剖根尖到主要根尖孔的距离以及主要根尖孔在根尖上的位置。
将926颗人牙的牙冠在牙骨质-釉质界处进行切片。将标本安装在显微镜载玻片上,以便平行于牙齿的长轴进行测量。主要根尖孔被确定为根尖处直径最大的开口。使用光学体视显微镜对总共1331个牙根标本进行评估,放大倍数为40倍(±10),精度为0.01毫米。测量从解剖根尖到主要根尖孔最根尖点的距离,并记录其位置(中央、颊侧、舌侧、近中及远中)。
主要根尖孔与解剖根尖之间的平均距离为0.69毫米;后牙的平均距离较大(0.82毫米),前牙的平均距离较小(0.39毫米)。在所有牙组中均观察到解剖根尖到主要根尖孔的距离范围较广:最大距离出现在上颌磨牙(0.95毫米),其次是下颌前磨牙(0.87毫米)和下颌磨牙(0.80毫米)。40%的牙齿中主要根尖孔位于根尖尖端。根尖孔最常见的偏移方向是颊侧(20%)和远中(14%)。
在这个无根尖吸收的牙齿样本中,主要根尖孔与解剖根尖之间的距离始终<1毫米。主要根尖孔相对于解剖根尖的偏移在不同牙组中差异很大。