Suppr超能文献

连续环形撕囊对散射光的影响。

Contributions of the capsulorrhexis to straylight.

作者信息

van der Meulen Ivanka J E, Engelbrecht Leonore A, Van Riet Tom C T, Lapid-Gortzak Ruth, Nieuwendaal Carla P, Mourits Maarten P, van den Berg Thomas J T P

机构信息

Department of Ophthalmology, Academic Medical Center, A2 Room 123.1, Meibergdreef 9, 1100 DD Amsterdam, the Netherlands.

出版信息

Arch Ophthalmol. 2009 Oct;127(10):1290-5. doi: 10.1001/archophthalmol.2009.255.

Abstract

OBJECTIVES

To quantify the effect of the capsulorrhexis on straylight and to determine optimal capsulorrhexis size.

METHODS

Fifty-six pseudophakic eyes with intact capsulorrhexis were included in the study. Straylight was measured with a straylight meter before and after pupil dilation. Capsulorrhexis and pupil diameter were measured and opacity of the anterior capsule was graded (on a scale of 0-5) with the slitlamp. Capsulorrhexis size and opacity were compared with the difference in straylight values between natural and dilated pupils.

RESULTS

The mean capsulorrhexis diameter was 4.5 mm (range, 2.9-6.2 mm). Most anterior capsular rims were opaque in the area of contact with the intraocular lens (62.5% higher than grade 1). Mean straylight before pupil dilation was log(s)=1.25 (range, 0.68-2.13), which increased to 1.46 (range, 0.88-2.22) after pupil dilation, which corresponds to a 62% increase (P <.001). The effect of capsulorrhexis size and opacity on the increase in straylight in scotopic conditions can be quantified by the following formula: Deltas = 19 x (grading of anterior capsular rim) x (fraction of pupil area covered by rhexis).

CONCLUSIONS

The influence of size and opacity of the capsulorrhexis via straylight is described in a quantitative model. Capsulorrhexis size must be greater than 4 mm to prevent functional problems at night.

摘要

目的

量化连续环形撕囊对散射光的影响并确定最佳连续环形撕囊尺寸。

方法

本研究纳入了56只连续环形撕囊完整的人工晶状体眼。在瞳孔散大前后用散射光计测量散射光。用裂隙灯测量连续环形撕囊和瞳孔直径,并对前囊膜混浊程度进行分级(0 - 5级)。将连续环形撕囊尺寸和混浊程度与自然瞳孔和散大瞳孔间散射光值的差异进行比较。

结果

连续环形撕囊平均直径为4.5毫米(范围2.9 - 6.2毫米)。大多数前囊边缘在与人工晶状体接触区域不透明(62.5%高于1级)。瞳孔散大前平均散射光log(s)=1.25(范围0.68 - 2.13),瞳孔散大后增至1.46(范围0.88 - 2.22),相当于增加了62%(P <.001)。在暗视条件下,连续环形撕囊尺寸和混浊程度对散射光增加的影响可用以下公式量化:Δs = 19×(前囊边缘分级)×(撕囊覆盖瞳孔面积的比例)。

结论

通过一个定量模型描述了连续环形撕囊大小和混浊程度对散射光的影响。连续环形撕囊尺寸必须大于4毫米以防止夜间出现功能问题。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验