EarLens Corporation, 200 Chesapeake Drive, Redwood City, CA 94063, USA.
Hear Res. 2010 May;263(1-2):104-13. doi: 10.1016/j.heares.2010.01.012. Epub 2010 Jan 29.
The hypothesis is tested that an open-canal hearing device, with a microphone in the ear canal, can be designed to provide amplification over a wide bandwidth and without acoustic feedback. In the design under consideration, a transducer consisting of a thin silicone platform with an embedded magnet is placed directly on the tympanic membrane. Sound picked up by a microphone in the ear canal, including sound-localization cues thought to be useful for speech perception in noisy environments, is processed and amplified, and then used to drive a coil near the tympanic-membrane transducer. The perception of sound results from the vibration of the transducer in response the electromagnetic field produced by the coil. Sixteen subjects (ranging from normal-hearing to moderately hearing-impaired) wore this transducer for up to a 10-month period, and were monitored for any adverse reactions. Three key functional characteristics were measured: (1) the maximum equivalent pressure output (MEPO) of the transducer; (2) the feedback gain margin (GM), which describes the maximum allowable gain before feedback occurs; and (3) the tympanic-membrane damping effect (D(TM)), which describes the change in hearing level due to placement of the transducer on the eardrum. Results indicate that the tympanic-membrane transducer remains in place and is well tolerated. The system can produce sufficient output to reach threshold for those with as much as 60 dBHL of hearing impairment for up to 8 kHz in 86% of the study population, and up to 11.2 kHz in 50% of the population. The feedback gain margin is on average 30 dB except at the ear-canal resonance frequencies of 3 and 9 kHz, where the average was reduced to 12 dB and 23 dB, respectively. The average value of D(TM) is close to 0 dB everywhere except in the 2-4 kHz range, where it peaks at 8dB. A new alternative system that uses photonic energy to transmit both the signal and power to a photodiode and micro-actuator on an EarLens platform is also described.
提出了一种假设,即可以设计一种带有耳道麦克风的开放式耳道听力设备,以提供宽频带和无声反馈的放大。在所考虑的设计中,将由带有嵌入式磁铁的薄硅平台组成的换能器直接放置在鼓膜上。耳道中的麦克风拾取的声音,包括被认为对嘈杂环境中的语音感知有用的声源定位线索,经过处理和放大,然后用于驱动鼓膜换能器附近的线圈。声音的感知是由于换能器响应线圈产生的电磁场而振动的结果。16 名受试者(从听力正常到中度听力障碍)佩戴这种换能器长达 10 个月,并监测任何不良反应。测量了三个关键功能特性:(1)换能器的最大等效压力输出(MEPO);(2)反馈增益裕量(GM),它描述了反馈发生之前允许的最大增益;(3)鼓膜阻尼效应(D(TM)),它描述了由于将换能器放置在鼓膜上而导致的听力水平的变化。结果表明,鼓膜换能器保持在位且耐受良好。该系统可以产生足够的输出,以使听力损失高达 60dBHL 的人在 86%的研究人群中达到阈值,在 50%的人群中达到 8kHz 的 11.2kHz。除了在耳道共振频率为 3kHz 和 9kHz 时,平均增益裕量为 30dB 外,平均增益裕量为 30dB。在耳道共振频率为 3kHz 和 9kHz 时,平均增益裕量分别降低到 12dB 和 23dB。除了在 2-4kHz 范围内达到峰值为 8dB 外,D(TM)的平均值接近 0dB。还描述了一种新的替代系统,该系统使用光子能量将信号和功率传输到基于 EarLens 平台的光电二极管和微执行器。