Department of Orthodontics, University of Catania, Italy.
Angle Orthod. 2011 Jan;81(1):36-41. doi: 10.2319/050910-250.1.
To test the null hypothesis that circumaxillary sutures do not show bony displacement in response to rapid maxillary expansion (RME) therapy.
Subjects consisted of eight growing patients (two male and six female) with Angle Class I malocclusion, bilateral posterior crossbite, transverse maxillary deficiency, deep palatal vault, and dental crowding at the start of the treatment. A Hyrax palatal expander was used for each patient, and activation protocol required the screw to be turned three times per day (0.25 mm per turn) for an average of 18 days for all subjects. Multislice computed tomography (CT) scans were performed before rapid palatal expansion (time T0) and again at the end of the active expansion phase (time T1) without removing the expander. Measurements were carried out directly on the CT image using the OsiriX Imaging software program. Data were analyzed statistically by using the Wilcoxon signed rank test.
All linear measurements showed an increase between T0 and T1 and RME determined a widening of suture; however, sutures far from the maxilla showed a smaller degree of disarticulation.
The hypothesis is rejected. Early treatment with RME produced a significant bony displacement by circumaxillary suture opening. The amount of changes of sutures depends on different factors relating to the subjects and varies between different sutures, showing that sutures that articulate directly with the maxilla face a greater influence by the RME compared with those located further away.
验证环牙槽突缝在快速上颌扩张(RME)治疗中不会发生骨移位的零假设。
研究对象为 8 名生长发育期的患者(2 名男性和 6 名女性),均患有安氏 I 类错牙合、双侧后牙反牙合、上颌横向发育不足、腭穹窿高、牙列拥挤。每位患者均使用 Hyrax 腭扩张器,螺杆每天旋转 3 次(每次旋转 0.25mm),所有患者的平均激活时间为 18 天。在快速腭扩张前(T0 时间)和主动扩张阶段结束时(T1 时间)进行多层 CT(CT)扫描,扩张器未取出。使用 OsiriX 成像软件程序直接在 CT 图像上进行测量。使用 Wilcoxon 符号秩检验对数据进行统计学分析。
所有线性测量均显示 T0 至 T1 之间的增加,RME 导致缝张开并增宽;然而,远离上颌的缝表现出较小程度的脱臼。
该假设被拒绝。早期 RME 治疗可通过环牙槽突缝的张开引起明显的骨移位。缝的变化量取决于与患者相关的不同因素,并且在不同的缝之间变化,表明与上颌直接相连的缝受到 RME 的影响更大,而位于更远的缝受到的影响较小。