Children's Orthopedics of Atlanta, Atlanta, GA, USA.
Spine (Phila Pa 1976). 2010 Nov 15;35(24):2109-15. doi: 10.1097/BRS.0b013e3181d323ab.
Retrospective, multicenter study of robotically-guided spinal implant insertions. Clinical acceptance of the implants was assessed by intraoperative radiograph, and when available, postoperative computed tomography (CT) scans were used to determine placement accuracy.
To verify the clinical acceptance and accuracy of robotically-guided spinal implants and compare to those of unguided free-hand procedures.
SpineAssist surgical robot has been used to guide implants and guide-wires to predefined locations in the spine. SpineAssist which, to the best of the authors' knowledge, is currently the sole robot providing surgical assistance in positioning tools in the spine, guided over 840 cases in 14 hospitals, between June 2005 and June 2009.
Clinical acceptance of 3271 pedicle screws and guide-wires inserted in 635 reported cases was assessed by intraoperative fluoroscopy, where placement accuracy of 646 pedicle screws inserted in 139 patients was measured using postoperative CT scans.
Screw placements were found to be clinically acceptable in 98% of the cases when intraoperatively assessed by fluoroscopic images. Measurements derived from postoperative CT scans demonstrated that 98.3% of the screws fell within the safe zone, where 89.3% were completely within the pedicle and 9% breached the pedicle by up to 2 mm. The remaining 1.4% of the screws breached between 2 and 4 mm, while only 2 screws (0.3%) deviated by more than 4 mm from the pedicle wall. Neurologic deficits were observed in 4 cases yet, following revisions, no permanent nerve damage was encountered, in contrast to the 0.6% to 5% of neurologic damage reported in the literature.
SpineAssist offers enhanced performance in spinal surgery when compared to free-hand surgeries, by increasing placement accuracy and reducing neurologic risks. In addition, 49% of the cases reported herein used a percutaneous approach, highlighting the contribution of SpineAssist in procedures without anatomic landmarks.
回顾性、多中心研究机器人引导脊柱植入物的插入。通过术中 X 光评估植入物的临床接受程度,如有可能,还将使用术后计算机断层扫描 (CT) 确定放置的准确性。
验证机器人引导脊柱植入物的临床接受程度和准确性,并与未引导的徒手手术进行比较。
脊柱辅助手术机器人已用于引导植入物和导丝到达脊柱的预定位置。脊柱辅助机器人是目前唯一一种在脊柱中定位工具的手术辅助机器人,截至 2009 年 6 月,在 14 家医院中,已对超过 840 例患者进行了超过 3271 枚椎弓根螺钉和导丝的手术,据作者所知,脊柱辅助机器人在过去的 4 年中得到了广泛的应用。
通过术中透视评估 635 例报告病例中的 3271 枚椎弓根螺钉和导丝的临床接受程度,通过术后 CT 扫描测量 139 例患者中 646 枚椎弓根螺钉的放置精度。
术中通过透视图像评估,98%的病例中螺钉放置被认为是临床可接受的。术后 CT 扫描测量结果显示,98.3%的螺钉位于安全区域内,其中 89.3%完全位于椎弓根内,9%穿透椎弓根但不超过 2mm。其余 1.4%的螺钉穿透 2 至 4mm,只有 2 枚螺钉(0.3%)偏离椎弓根壁超过 4mm。虽然有 4 例出现神经功能缺损,但经修正后,没有发现永久性神经损伤,而文献报道的神经损伤发生率为 0.6%至 5%。
与徒手手术相比,脊柱辅助机器人通过提高植入物的放置精度和降低神经风险,在脊柱手术中提供了更好的性能。此外,本文报告的病例中有 49%采用了经皮入路,这突出了脊柱辅助机器人在无解剖标志的手术中的贡献。