Thayer School of Engineering, Dartmouth College, Hanover, New Hampshire 03755, USA.
Biotechnol Bioeng. 2011 Jun;108(6):1268-78. doi: 10.1002/bit.23050. Epub 2011 Feb 18.
Studies were undertaken to understand phenomena operative during simultaneous saccharification and fermentation (SSF) of a model cellulosic substrate (Avicel) at 50°C with enzymatic hydrolysis mediated by a commercial cellulase preparation (Spezyme CP) and fermentation by a thermophilic bacterium engineered to produce ethanol at high yield, Thermoanaerobacterium saccharolyticum ALK2. Thermal inactivation at 50 °C, as shown by the loss of 50% of enzyme activity over 4 days in the absence of ethanol, was more severe than at 37 °C, where only 25% of enzyme activity was lost. In addition, at 50 °C ethanol more strongly influenced enzyme stability. Enzyme activity was moderately stabilized between ethanol concentrations of 0 and 40 g/L, but ethanol concentrations above 40 g/L accelerated enzyme inactivation, leading to 75% loss of enzymatic activity in 80 g/L ethanol after 4 days. At 37 °C, ethanol did not show a strong effect on the rate of enzyme inactivation. Inhibition of cellulase activity by ethanol, measured at both temperatures, was relatively similar, with the relative rate of hydrolysis inhibited 50% at ethanol concentrations of 56.4 and 58.7 g/L at 50 and 37 °C, respectively. A mathematical model was developed to test whether the measured phenomena were sufficient to quantitatively describe system behavior and was found to have good predictive capability at initial Avicel concentrations of 20 and 50 g/L.
进行了研究,以了解在 50°C 下通过商业纤维素酶制剂(Spezyme CP)进行酶解和通过经工程改造以高产乙醇的嗜热细菌发酵(Thermoanaerobacterium saccharolyticum ALK2)进行同步糖化和发酵(SSF)时作用的现象。在没有乙醇的情况下,50°C 下的热失活(在 4 天内失去 50%的酶活性)比 37°C 下更严重,在 37°C 下仅失去 25%的酶活性。此外,在 50°C 下,乙醇更强烈地影响酶稳定性。在 0 至 40 g/L 的乙醇浓度之间,酶活性得到适度稳定,但乙醇浓度高于 40 g/L 会加速酶失活,导致在 4 天后 80 g/L 的乙醇中酶活性损失 75%。在 37°C 下,乙醇对酶失活速率没有强烈影响。在这两种温度下测量的纤维素酶活性抑制作用相对相似,水解的相对速率在 50°C 和 37°C 下分别在乙醇浓度为 56.4 和 58.7 g/L 时被抑制了 50%。开发了一个数学模型来测试所测量的现象是否足以定量描述系统行为,并发现该模型在初始微晶纤维素浓度为 20 和 50 g/L 时具有良好的预测能力。