Aerodyne Research, Inc, 45 Manning Road, Billerica Massachusetts 01821, United States.
Environ Sci Technol. 2013 Apr 2;47(7):3513-20. doi: 10.1021/es304349c. Epub 2013 Mar 8.
Drawing from a series of field measurement activities including the Alternative Aviation Fuels Experiments (AAFEX1 and AAFEX2), we present experimental measurements of particle number, size, and composition-resolved mass that describe the physical and chemical evolution of aircraft exhaust plumes on the time scale of 5 s to 2-3 min. As the plume ages, the particle number emission index initially increases by a factor of 10-50, due to gas-to-particle formation of a nucleation/growth mode, and then begins to fall with increased aging. Increasing the fuel sulfur content causes the initial increase to occur more rapidly. The contribution of the nucleation/growth mode to the overall particle number density is most pronounced at idle power and decreases with increasing engine power. Increasing fuel sulfur content, but not fuel aromatic content causes the nucleation/growth mode to dominate the particle number emissions at higher powers than for a fuel with "normal" sulfur and aromatic content. Particle size measurements indicate that the observed particle number emissions trends are due to continuing gas-to-particle conversion and coagulation growth of the nucleation/growth mode particles, processes which simultaneously increase particle mass and reduce particle number density. Measurements of nucleation/growth mode mass are consistent with the interpretation of particle number and size data and suggest that engine exit plane measurements may underestimate the total particle mass by as much as a factor of between 5 and 10.
从一系列现场测量活动中,包括替代航空燃料实验(AAFEX1 和 AAFEX2),我们展示了对飞机排气羽流的粒子数、大小和组成分辨质量的实验测量结果,这些结果描述了飞机排气羽流在 5 秒到 2-3 分钟的时间尺度上的物理和化学演化。随着羽流的老化,粒子数排放指数最初增加了 10-50 倍,这是由于成核/生长模式的气体到粒子的形成,然后随着老化的增加开始下降。增加燃料中的硫含量会导致初始增加更快地发生。成核/生长模式对总粒子数密度的贡献在怠速时最为明显,并且随着发动机功率的增加而减小。增加燃料中的硫含量,但不增加燃料中的芳烃含量,会导致成核/生长模式在比具有“正常”硫和芳烃含量的燃料更高的功率下主导粒子数排放。粒子大小测量表明,观察到的粒子数排放趋势是由于持续的气体到粒子的转化和核化/生长模式粒子的凝聚生长,这些过程同时增加了粒子质量并降低了粒子数密度。成核/生长模式质量的测量结果与粒子数和大小数据的解释一致,并表明发动机出口平面的测量结果可能低估了总粒子质量,幅度在 5 到 10 倍之间。