Suppr超能文献

载多西紫杉醇聚合物纳米粒的抗肿瘤活性的制备工艺 Shirasu 多孔玻璃膜乳化技术。

Antitumor activity of docetaxel-loaded polymeric nanoparticles fabricated by Shirasu porous glass membrane-emulsification technique.

机构信息

Tongji School of Pharmacy, Huazhong University of Science and Technology, Wuhan, People’s Republic of China.

出版信息

Int J Nanomedicine. 2013;8:2641-52. doi: 10.2147/IJN.S48214. Epub 2013 Jul 29.

Abstract

Docetaxel (DTX) has excellent efficiency against a wide spectrum of cancers. However, the current clinical formulation has limited its usage, as it causes some severe side effects. Various polymeric nanoparticles have thus been developed as alternative formulations of DTX, but they have been mostly fabricated on a laboratory scale. Previously, we synthesized a novel copolymer, poly(lactide)-D-α-tocopheryl polyethylene glycol 1000 succinate (PLA-TPGS), and found that it exhibited great potential in drug delivery with improved properties. In this study, we applied the Shirasu porous glass (SPG) membrane-emulsification technique to prepare the DTX-loaded PLA-TPGS nanoparticles on a pilot scale. The effect of several formulation variables on the DTX-loaded nanoparticle properties, including particle size, zeta potential, and drug-encapsulation efficiency, were investigated based on surfactant type and concentration in the aqueous phase, organic/aqueous phase volumetric ratio, membrane-pore size, transmembrane cycles, and operation pressure. The DTX-loaded nanoparticles were obtained with sizes of 306.8 ± 5.5 nm and 334.1 ± 2.7 nm (mean value ± standard deviation), and drug-encapsulation efficiency of 81.8% ± 4.5% and 64.5% ± 2.7% for PLA-TPGS and poly(lactic-co-glycolic acid) (PLGA) nanoparticles, respectively. In vivo pharmacokinetic study exhibited a significant advantage of PLA-TPGS nanoparticles over PLGA nanoparticles and Taxotere. Drug-loaded PLA-TPGS nanoparticles exhibited 1.78-, 6.34- and 3.35-fold higher values for area under the curve, half-life, and mean residence time, respectively, compared with those of PLGA nanoparticles, and 2.23-, 13.2-, 8.51-fold higher than those of Taxotere, respectively. In vivo real-time distribution of nanoparticles was measured on tumor-bearing mice by near-infrared fluorescence imaging, which demonstrated that the PLA-TPGS nanoparticles achieved much higher concentration and longer retention in tumors than PLGA nanoparticles after intravenous injection. This is consistent with the pharmacokinetic behavior of the nanoparticles. The tumor-inhibitory effect of DTX-loaded nanoparticles was observed in vivo in an H22 tumor-bearing mice model via intravenous administration. This indicated that PLA-TPGS nanoparticles are a feasible drug-delivery formulation with a pilot fabrication technique and have superior pharmacokinetic and anticancer effects compared to the commercially available Taxotere.

摘要

多西紫杉醇(DTX)对广泛谱的癌症具有优异的疗效。然而,目前的临床制剂限制了其应用,因为它会引起一些严重的副作用。因此,各种聚合物纳米粒已被开发为 DTX 的替代制剂,但它们大多是在实验室规模上制备的。以前,我们合成了一种新型共聚物,聚(丙交酯)-D-α-生育酚聚乙二醇 1000 琥珀酸酯(PLA-TPGS),并发现它在改善性能的药物传递方面具有很大的潜力。在本研究中,我们应用 Shirasu 多孔玻璃(SPG)膜乳化技术在中试规模上制备载多西紫杉醇的 PLA-TPGS 纳米粒。研究了表面活性剂类型和浓度、有机/水相体积比、膜孔大小、跨膜循环和操作压力等制剂变量对载药纳米粒性质(包括粒径、Zeta 电位和药物包封效率)的影响。获得的载多西紫杉醇纳米粒的粒径分别为 306.8±5.5nm 和 334.1±2.7nm(平均值±标准差),载药效率分别为 81.8%±4.5%和 64.5%±2.7%,对于 PLA-TPGS 和聚(乳酸-共-乙醇酸)(PLGA)纳米粒。体内药代动力学研究表明 PLA-TPGS 纳米粒优于 PLGA 纳米粒和 Taxotere。与 PLGA 纳米粒相比,载药 PLA-TPGS 纳米粒的曲线下面积、半衰期和平均滞留时间分别提高了 1.78 倍、6.34 倍和 3.35 倍,与 Taxotere 相比,分别提高了 2.23 倍、13.2 倍和 8.51 倍。通过近红外荧光成像在荷瘤小鼠上测量了纳米粒的体内实时分布,结果表明,静脉注射后 PLA-TPGS 纳米粒在肿瘤中的浓度和滞留时间明显高于 PLGA 纳米粒。这与纳米粒的药代动力学行为一致。通过静脉注射荷 H22 肿瘤小鼠模型,观察到载多西紫杉醇纳米粒的体内肿瘤抑制作用。这表明 PLA-TPGS 纳米粒是一种可行的药物传递制剂,具有中试规模的制备技术,与市售的 Taxotere 相比,具有更好的药代动力学和抗癌效果。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/451f/3735276/4d187bba59a8/ijn-8-2641Fig1.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验