From the Ludwig Boltzmann Institute for Experimental and Clinical Traumatology and AUVA Research Centre, Vienna; Department of Anesthesiology and Intensive Care, Salzburger Landeskliniken SALK, Salzburg, Austria; CSL Behring, Marburg, Germany; Department of Cardiothoracic and Vascular Anesthesia and Intensive Care, IRCCS Policlinico San Donato, Milan, Italy; and Department of Anesthesiology and Intensive Care, AUVA Trauma Hospital of Salzburg, Salzburg, Austria.
Anesth Analg. 2014 Feb;118(2):269-276. doi: 10.1213/ANE.0000000000000058.
Viscoelastic tests such as functional fibrinogen polymerization assays (FFPAs) in thrombelastography (TEG®) or thromboelastometry (ROTEM®) measure clot elasticity under platelet inhibition. Incomplete platelet inhibition influences maximum clot firmness (MCF) of FFPAs. We compared the ability of existing and newly developed FFPAs to eliminate the platelet contribution to clot strength.
MCF of whole blood (WB), platelet-rich plasma (PRP), and platelet-poor plasma samples was recorded using a ROTEM device with different FFPAs, including the TEG functional fibrinogen test (FFTEG) and different ROTEM-based assays: the standard fib-tem reagent (FIBTEM), a lyophilized single-portion reagent fib-tem S (FIBTEM-S), a newly developed reagent FIBTEM PLUS, as well as FIBTEM or the standard extrinsic activation reagent ex-tem® (EXTEM) combined with 10-μg abciximab (FIBTEM-ABC/EXTEM-ABC).
In WB (platelet count [mean ± SD], 183 ± 37 × 10/μL; plasma fibrinogen concentration, 2.49 ± 0.58 g/L), FFTEG and EXTEM-ABC showed higher MCF (15.7 ± 2.8 mm) than FIBTEM or FIBTEM-S (11.4 ± 3.3 mm, P < 0.001), whereas FIBTEM-ABC and FIBTEM PLUS resulted in lower MCF (9.3 ± 2.8 mm, P < 0.001). In 2 different PRP samples, with platelet counts of 407 ± 80 × 10/μL and 609 ± 127 × 10/μL, FIBTEM-ABC and FIBTEM PLUS reduced platelet contribution to clot strength within 95% confidence interval limits of -1.4 to 0.1 mm and -1.2 to 0.4 mm, respectively. Using all FFPAs it was observed that the Pearson correlation coefficient between plasma fibrinogen concentration and WB MCF was high (range, 0.75-0.93) and significant, regardless of the underlying platelet inhibiting component. Evaluating differences in the interception of regression lines by using analysis of covariance, we compared platelet-poor plasma and both PRP samples within the same assays and found that in contrast to the FIBTEM-ABC and FIBTEM PLUS assays, the FFTEG, EXTEM-ABC, FIBTEM, and FIBTEM-S methods still detected residual platelet activity and grossly overestimated fibrin clot strength in samples with high platelet counts.
FFPAs based solely on glycoprotein-IIb/IIIa inhibition, such as FFTEG or EXTEM-ABC, are less effective than cytochalasin D-based assays, such as FIBTEM or FIBTEM-S, at inhibiting the platelet component of clot strength. The FIBTEM PLUS assay, and the combination of FIBTEM and abciximab, sufficiently inhibits platelet contribution to clot elasticity. The combination of a glycoprotein-IIb/IIIa receptor blocker and cytochalasin D allows evaluation of functional fibrinogen polymerization without platelet "noise." In a clinical setting, the significance of potent platelet inhibition ensures a more accurate assessment of MCF and therefore the need for fibrinogen supplementation therapy. Further studies are necessary to investigate the application and impact of these tests in a clinical situation.
血栓弹力描记术(TEG®)或血栓弹性测量法(ROTEM®)中的黏弹性测试,如功能性纤维蛋白原聚合测定(FFPA),可在血小板抑制下测量血凝块的弹性。不完全的血小板抑制会影响 FFPA 的最大血凝块硬度(MCF)。我们比较了现有的和新开发的 FFPA 消除血小板对血凝块强度贡献的能力。
使用 ROTEM 设备记录全血(WB)、富含血小板的血浆(PRP)和血小板减少的血浆样本的 MCF,使用不同的 FFPA,包括 TEG 功能性纤维蛋白原测试(FFTEG)和不同的基于 ROTEM 的测定方法:标准纤维-TEG 试剂(FIBTEM)、冻干单份试剂纤维-TEM S(FIBTEM-S)、新开发的试剂 FIBTEM PLUS 以及纤维-TEM 或标准外源性激活试剂 ex-tem®(EXTEM)与 10-μg 依替巴肽(FIBTEM-ABC/EXTEM-ABC)联合使用。
在 WB(血小板计数[平均值±标准差],183±37×10/μL;血浆纤维蛋白原浓度,2.49±0.58 g/L)中,FFTEG 和 EXTEM-ABC 的 MCF (15.7±2.8 mm)高于 FIBTEM 或 FIBTEM-S(11.4±3.3 mm,P<0.001),而 FIBTEM-ABC 和 FIBTEM PLUS 导致 MCF (9.3±2.8 mm,P<0.001)较低。在 2 种不同的 PRP 样本中,血小板计数分别为 407±80×10/μL 和 609±127×10/μL,FIBTEM-ABC 和 FIBTEM PLUS 降低了血小板对血凝块强度的贡献,置信区间范围为-1.4 至 0.1mm 和-1.2 至 0.4mm。使用所有 FFPA 观察到,血浆纤维蛋白原浓度与 WB MCF 之间的 Pearson 相关系数较高(范围为 0.75-0.93)且具有统计学意义,无论潜在的血小板抑制成分如何。使用协方差分析比较回归线的截距差异,我们在相同的测定方法中比较了血小板减少的血浆和两种 PRP 样本,发现与 FIBTEM-ABC 和 FIBTEM PLUS 测定方法相反,FFTEG、EXTEM-ABC、FIBTEM 和 FIBTEM-S 方法仍然检测到残留的血小板活性,并在血小板计数较高的样本中严重高估纤维蛋白凝块强度。
仅基于糖蛋白 IIb/IIIa 抑制的 FFPA,如 FFTEG 或 EXTEM-ABC,在抑制血凝块强度的血小板成分方面,不如基于细胞松弛素 D 的测定方法(如 FIBTEM 或 FIBTEM-S)有效。FIBTEM PLUS 测定法和 FIBTEM 与依替巴肽的联合应用足以抑制血小板对血凝块弹性的贡献。糖蛋白 IIb/IIIa 受体阻滞剂和细胞松弛素 D 的联合应用允许在没有血小板“噪声”的情况下评估功能性纤维蛋白原聚合。在临床环境中,强有力的血小板抑制的意义确保了 MCF 的更准确评估,因此需要纤维蛋白原补充治疗。需要进一步研究这些测试在临床情况下的应用和影响。