Suppr超能文献

模拟细胞组装状态并激活CheA自磷酸化的预形成可溶性化学感受器三聚体。

Preformed Soluble Chemoreceptor Trimers That Mimic Cellular Assembly States and Activate CheA Autophosphorylation.

作者信息

Greenswag Anna R, Li Xiaoxiao, Borbat Peter P, Samanta Dipanjan, Watts Kylie J, Freed Jack H, Crane Brian R

机构信息

†Department of Chemistry and Chemical Biology, Cornell University, Ithaca, New York 14853, United States.

‡Center for Advanced ESR Studies, Cornell University, Ithaca, New York 14853, United States.

出版信息

Biochemistry. 2015 Jun 9;54(22):3454-68. doi: 10.1021/bi501570n. Epub 2015 May 28.

Abstract

Bacterial chemoreceptors associate with the histidine kinase CheA and coupling protein CheW to form extended membrane arrays that receive and transduce environmental signals. A receptor trimers-of-dimers resides at each vertex of the hexagonal protein lattice. CheA is fully activated and regulated when it is integrated into the receptor assembly. To mimic these states in solution, we have engineered chemoreceptor cytoplasmic kinase-control modules (KCMs) based on the Escherichia coli aspartate receptor Tar that are covalently fused and trimerized by a foldon domain (Tar(FO)). Small-angle X-ray scattering, multi-angle light scattering, and pulsed-dipolar electron spin resonance spectroscopy of spin-labeled proteins indicate that the Tar(FO) modules assemble into homogeneous trimers wherein the protein interaction regions closely associate at the end opposite to the foldon domains. The Tar(FO) variants greatly increase the saturation levels of phosphorylated CheA (CheA-P), indicating that the association with a trimer of receptor dimers changes the fraction of active kinase. However, the rate constants for CheA-P formation with the Tar variants are low compared to those for autophosphorylation by free CheA, and net phosphotransfer from CheA to CheY does not increase commensurately with CheA autophosphorylation. Thus, the Tar variants facilitate slow conversion to an active form of CheA that then undergoes stable autophosphorylation and is capable of subsequent phosphotransfer to CheY. Free CheA is largely incapable of phosphorylation but contains a small active fraction. Addition of Tar(FO) to CheA promotes a planar conformation of the regulatory domains consistent with array models for the assembly state of the ternary complex and different from that observed with a single inhibitory receptor. Introduction of Tar(FO) into E. coli cells activates endogenous CheA to produce increased clockwise flagellar rotation, with the effects increasing in the presence of the chemotaxis methylation system (CheB/CheR). Overall, the Tar(FO) modules demonstrate that trimerized signaling tips self-associate, bind CheA and CheW, and facilitate conversion of CheA to an active conformation.

摘要

细菌化学感受器与组氨酸激酶CheA和偶联蛋白CheW结合,形成延伸的膜阵列,以接收和转导环境信号。受体二聚体三聚体位于六边形蛋白质晶格的每个顶点。当CheA整合到受体组件中时,它会被完全激活和调节。为了在溶液中模拟这些状态,我们基于大肠杆菌天冬氨酸受体Tar设计了化学感受器细胞质激酶控制模块(KCM),该模块通过一个折叠域(Tar(FO))共价融合并三聚化。自旋标记蛋白的小角X射线散射、多角度光散射和脉冲偶极电子自旋共振光谱表明,Tar(FO)模块组装成均匀的三聚体,其中蛋白质相互作用区域在与折叠域相对的末端紧密结合。Tar(FO)变体极大地提高了磷酸化CheA(CheA-P)的饱和水平,表明与受体二聚体三聚体的结合改变了活性激酶的比例。然而,与游离CheA自磷酸化的速率常数相比,Tar变体形成CheA-P的速率常数较低,并且从CheA到CheY的净磷酸转移并未与CheA自磷酸化相应增加。因此,Tar变体促进了CheA缓慢转化为活性形式,然后进行稳定的自磷酸化,并能够随后将磷酸转移到CheY。游离CheA在很大程度上不能进行磷酸化,但含有一小部分活性成分。向CheA中添加Tar(FO)会促进调节域的平面构象,这与三元复合物组装状态的阵列模型一致,并且与单个抑制性受体观察到的构象不同。将Tar(FO)引入大肠杆菌细胞会激活内源性CheA,从而增加顺时针鞭毛旋转,在趋化甲基化系统(CheB/CheR)存在的情况下,这种影响会增强。总体而言,Tar(FO)模块表明三聚化的信号传导末端会自我结合、结合CheA和CheW,并促进CheA转化为活性构象。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/ce44/4772074/5ceea9dd638e/bi-2014-01570n_0001.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验