Suppr超能文献

一种源自棉花的肽-纤维素气凝胶蛋白酶传感器的制备、表征及活性

Preparation, Characterization and Activity of a Peptide-Cellulosic Aerogel Protease Sensor from Cotton.

作者信息

Edwards J Vincent, Fontenot Krystal R, Prevost Nicolette T, Pircher Nicole, Liebner Falk, Condon Brian D

机构信息

Southern Regional Research Center, USDA, New Orleans, LA 70124, USA.

Division of Chemistry of Renewable Resources, University of Natural Resources and Life Sciences Vienna, Konrad-Lorenz-Straße 24, Tulln an der Donau A-3430, Austria.

出版信息

Sensors (Basel). 2016 Oct 26;16(11):1789. doi: 10.3390/s16111789.

Abstract

Nanocellulosic aerogels (NA) provide a lightweight biocompatible material with structural properties, like interconnected high porosity and specific surface area, suitable for biosensor design. We report here the preparation, characterization and activity of peptide-nanocellulose aerogels (PepNA) made from unprocessed cotton and designed with protease detection activity. Low-density cellulosic aerogels were prepared from greige cotton by employing calcium thiocyanate octahydrate/lithium chloride as a direct cellulose dissolving medium. Subsequent casting, coagulation, solvent exchange and supercritical carbon dioxide drying afforded homogeneous cellulose II aerogels of fibrous morphology. The cotton-based aerogel had a porosity of 99% largely dominated by mesopores (2-50 nm) and an internal surface of 163 m²·g. A fluorescent tripeptide-substrate (succinyl-alanine-proline-alanine-4-amino-7-methyl-coumarin) was tethered to NA by (1) esterification of cellulose C6 surface hydroxyl groups with glycidyl-fluorenylmethyloxycarbonyl (FMOC), (2) deprotection and (3) coupling of the immobilized glycine with the tripeptide. Characterization of the NA and PepNA included techniques, such as elemental analysis, mass spectral analysis, attenuated total reflectance infrared imaging, nitrogen adsorption, scanning electron microscopy and bioactivity studies. The degree of substitution of the peptide analog attached to the anhydroglucose units of PepNA was 0.015. The findings from mass spectral analysis and attenuated total reflectance infrared imaging indicated that the peptide substrate was immobilized on to the surface of the NA. Nitrogen adsorption revealed a high specific surface area and a highly porous system, which supports the open porous structure observed from scanning electron microscopy images. Bioactivity studies of PepNA revealed a detection sensitivity of 0.13 units/milliliter for human neutrophil elastase, a diagnostic biomarker for inflammatory diseases. The physical properties of the aerogel are suitable for interfacing with an intelligent protease sequestrant wound dressing.

摘要

纳米纤维素气凝胶(NA)提供了一种具有结构特性的轻质生物相容性材料,如相互连接的高孔隙率和比表面积,适用于生物传感器设计。我们在此报告由未加工棉花制成并设计用于蛋白酶检测活性的肽 - 纳米纤维素气凝胶(PepNA)的制备、表征及活性。通过使用八水合硫氰酸钙/氯化锂作为直接纤维素溶解介质,由坯布棉制备低密度纤维素气凝胶。随后的浇铸、凝固、溶剂交换和超临界二氧化碳干燥得到了具有纤维形态的均匀纤维素II气凝胶。基于棉花的气凝胶孔隙率为99%,主要由中孔(2 - 50纳米)主导,内表面积为163平方米/克。一种荧光三肽底物(琥珀酰 - 丙氨酸 - 脯氨酸 - 丙氨酸 - 4 - 氨基 - 7 - 甲基香豆素)通过以下步骤连接到NA上:(1)用芴甲氧羰基缩水甘油(FMOC)对纤维素C6表面羟基进行酯化,(2)脱保护,(3)将固定化的甘氨酸与三肽偶联。NA和PepNA的表征包括元素分析、质谱分析、衰减全反射红外成像、氮吸附、扫描电子显微镜和生物活性研究等技术。连接到PepNA脱水葡萄糖单元上的肽类似物的取代度为0.015。质谱分析和衰减全反射红外成像的结果表明肽底物固定在NA表面。氮吸附显示出高比表面积和高度多孔系统,这支持了从扫描电子显微镜图像中观察到的开放多孔结构。PepNA的生物活性研究表明对人中性粒细胞弹性蛋白酶(一种炎症性疾病的诊断生物标志物)的检测灵敏度为0.13单位/毫升。气凝胶的物理性质适合与智能蛋白酶螯合剂伤口敷料连接。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/dffa/5134448/c053f4f95105/sensors-16-01789-g001.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验