Simon Jacob C, Kang Hobin, Staninec Michal, Jang Andrew T, Chan Kenneth H, Darling Cynthia L, Lee Robert C, Fried Daniel
University of California, San Francisco, California 94143-0758.
Lasers Surg Med. 2017 Mar;49(3):215-224. doi: 10.1002/lsm.22641. Epub 2017 Mar 24.
Radiographic methods have poor sensitivity for occlusal lesions and by the time the lesions are radiolucent they have typically progressed deep into the dentin. New more sensitive imaging methods are needed to detect occlusal lesions. In this study, cross-polarization optical coherence tomography (CP-OCT) and near-IR imaging were used to image questionable occlusal lesions (QOC's) that were not visible on radiographs but had been scheduled for restoration on 30 test subjects.
Near-IR reflectance and transillumination probes incorporating a high definition InGaAs camera and near-IR broadband light sources were used to acquire images of the lesions before restoration. The reflectance probe utilized cross-polarization and operated at wavelengths from 1,500 to 1,700 nm where there is an increase in water absorption for higher contrast. The transillumination probe was operated at 1,300 nm where the transparency of enamel is highest. Tomographic images (6 × 6 × 7 mm ) of the lesions were acquired using a high-speed swept-source CP-OCT system operating at 1,300 nm before and after removal of the suspected lesion.
Near-IR reflectance imaging at 1,500-1,700 nm yielded significantly higher contrast (P < 0.05) of the demineralization in the occlusal grooves compared with visible reflectance imaging. Stains in the occlusal grooves greatly reduced the lesion contrast in the visible range yielding negative values. Only half of the 26 lesions analyzed showed the characteristic surface demineralization and increased reflectivity below the dentinal-enamel junction (DEJ) in 3D OCT images indicative of penetration of the lesion into the dentin.
This study demonstrates that near-IR imaging methods have great potential for improving the early diagnosis of occlusal lesions. Lasers Surg. Med. 49:215-224, 2017. © 2017 Wiley Periodicals, Inc.
放射成像方法对咬合面病变的敏感性较差,当病变出现透射影像时,通常已深入牙本质深层。因此需要更新、更敏感的成像方法来检测咬合面病变。在本研究中,采用交叉偏振光学相干断层扫描(CP-OCT)和近红外成像技术,对30名受试对象的可疑咬合面病变(QOC)进行成像,这些病变在X光片上不可见,但已计划进行修复。
使用配备高清铟镓砷相机和近红外宽带光源的近红外反射和透照探头,在修复前获取病变图像。反射探头利用交叉偏振,工作波长为1500至1700纳米,此时水吸收增加,对比度更高。透照探头工作波长为1300纳米,此时釉质透明度最高。在去除可疑病变前后,使用工作波长为1300纳米的高速扫频源CP-OCT系统获取病变的断层图像(6×6×7毫米)。
与可见光反射成像相比,1500 - 1700纳米的近红外反射成像在咬合沟脱矿方面产生了显著更高的对比度(P < 0.05)。咬合沟中的污渍在可见光范围内大大降低了病变对比度,产生负值。在分析的26个病变中,只有一半在三维OCT图像中显示出特征性的表面脱矿以及牙本质-釉质界(DEJ)下方反射率增加,表明病变已侵入牙本质。
本研究表明,近红外成像方法在改善咬合面病变的早期诊断方面具有巨大潜力。《激光外科与医学》49:215 - 224,2017年。© 2017威利期刊公司