Department of Food Science, Nutrition and Health Promotion, Mississippi State University, Mississippi State, MS, 39762, USA.
Department of Poultry Science, Mississippi State University, Mississippi State, MS, 39762, USA.
Food Microbiol. 2018 Sep;74:143-150. doi: 10.1016/j.fm.2018.03.013. Epub 2018 Mar 29.
The objective of this study was to determine the growth and survival of Salmonella enterica in the presence of high and low concentrations (375 μg/ml and 15 μg/ml) of catfish mucus extract at 10 °C and 22 °C for 63 days. The second objective of this study was to investigate the biofilm formation of Salmonella enterica serovar Blockley (7175) in catfish mucus extract for 48 h at 22 °C on four food-contact surfaces and to observe the biofilm populations using Scanning Electron Microscopy (SEM). The surface properties, surface roughness and surface energies were determined using contact angle measurement and atomic force microscopy. In 375 μg/ml of catfish mucus extract that was inoculated with 3 log CFU/ml, the growth of Salmonella counts were increased to a maximum of 6-7 log CFU/ml at 10 °C and 7-8 log CFU/ml at 22 °C in 7-14 d and decreased by 1-2 log CFU/ml from these peak levels at both 10 °C and 22 °C from 21 to 63 d. In 15 μg/ml of catfish mucus extract, Salmonella counts were in the range of 4-5 log CFU/ml at 10 °C and 5-6 log CFU/ml at 22 °C over 7-63 d of storage. By contrast, Salmonella counts were non-detectable in the absence of catfish mucus by 21-28 d of storage at 10 °C or 22 °C. The biofilm counts of S. Blockley (7175) on a stainless steel surface were 4 log CFU/cm and 5.5 log CFU/cm in 15 μg/ml and 375 μg/ml of catfish mucus extract respectively after 48 h incubation at 22 °C. SEM revelead that biofilm formation by S. Blockley (7175) was less in 15 μg/ml than 375 μg/ml of catfish mucus extract on stainless steel. In addition, SEM indicated that the visible biofilms were least on buna-N rubber as compared to stainless steel, polyethylene and polyurethane surfaces. Contact angle and atomic force microscopy confirmed that buna-N rubber was highly hydrophobic with low surface energy and low roughness when compared to other three surfaces. These findings indicate that Salmonella can utilize catfish mucus as a nutrient source to survive for longer periods and promote biofilm formation for its persistence on different food-contact surfaces.
本研究的目的是确定在 10°C 和 22°C 下,高浓度(375μg/ml)和低浓度(15μg/ml)鲶鱼黏液提取物存在的情况下,鼠伤寒沙门氏菌的生长和存活情况,时间长达 63 天。本研究的第二个目的是研究鼠伤寒沙门氏菌血清型 Blockley(7175)在 22°C 下于鲶鱼黏液提取物中形成生物膜的情况,在四种食品接触表面上培养 48 小时,并使用扫描电子显微镜(SEM)观察生物膜种群。通过接触角测量和原子力显微镜确定表面特性、表面粗糙度和表面能。在 375μg/ml 的鲶鱼黏液提取物中接种 3 log CFU/ml 的细菌,在 10°C 下,鼠伤寒沙门氏菌的数量增加到最大 6-7 log CFU/ml,在 22°C 下增加到 7-8 log CFU/ml,在 7-14 天内,在 10°C 和 22°C 下,从这些峰值水平下降 1-2 log CFU/ml,持续 21-63 天。在 15μg/ml 的鲶鱼黏液提取物中,在 10°C 下鼠伤寒沙门氏菌的数量在 4-5 log CFU/ml 之间,在 22°C 下在 5-6 log CFU/ml 之间,在 7-63 天的储存过程中。相比之下,在 10°C 或 22°C 下储存 21-28 天时,在没有鲶鱼黏液的情况下,鼠伤寒沙门氏菌的数量无法检测到。22°C 孵育 48 小时后,不锈钢表面上 S. Blockley(7175)的生物膜数量分别为 15μg/ml 和 375μg/ml 的鲶鱼黏液提取物中的 4 log CFU/cm 和 5.5 log CFU/cm。SEM 显示,与不锈钢相比,在 15μg/ml 的鲶鱼黏液提取物中,S. Blockley(7175)的生物膜形成较少。此外,SEM 表明,与不锈钢、聚乙烯和聚氨酯表面相比,在 buna-N 橡胶上可见的生物膜最少。接触角和原子力显微镜证实,与其他三个表面相比,buna-N 橡胶的疏水性高,表面能低,粗糙度低。这些发现表明,沙门氏菌可以利用鲶鱼黏液作为营养源,在不同的食品接触表面上更长时间地存活并促进生物膜形成,从而保持其持久性。