Department of Imaging, Dana Farber Cancer Institute, Boston, MA 02215, United States of America.
Phys Med Biol. 2019 Dec 13;64(24):245001. doi: 10.1088/1361-6560/ab58fe.
Multi-pinhole (MPH) collimators are known to provide better trade-off between sensitivity and resolution for preclinical, as well as for smaller regions in clinical SPECT imaging compared to conventional collimators. In addition to this geometric advantage, MPH plates typically offer better stopping power for penetration than the conventional collimators, which is especially relevant for I-123 imaging. The I-123 emits a series of high-energy (>300 keV, ~2.5% abundance) gamma photons in addition to the primary emission (159 keV, 83% abundance). Despite their low abundance, high-energy photons penetrate through a low-energy parallel-hole (LEHR) collimator much more readily than the 159 keV photons, resulting in large downscatter in the photopeak window. In this work, we investigate the primary, scatter, and penetration characteristics of a single pinhole collimator that is commonly used for I-123 thyroid imaging and our two MPH collimators designed for I-123 DaTscan imaging for Parkinson's Disease, in comparison to three different parallel-hole collimators through a series of experiments and Monte Carlo simulations. The simulations of a point source and a digital human phantom with DaTscan activity distribution showed that our MPH collimators provide superior count performance in terms of high primary counts, low penetration, and low scatter counts compared to the parallel-hole and single pinhole collimators. For example, total scatter, multiple scatter, and collimator penetration events for the LEHR were 2.5, 7.6 and 14 times more than that of MPH within the 15% photopeak window. The total scatter fraction for LEHR was 56% where the largest contribution came from the high-energy scatter from the back compartments (31%). For the same energy window, the total scatter for MPH was 21% with only 1% scatter from the back compartments. We therefore anticipate that using MPH collimators, higher quality reconstructions can be obtained in a substantially shorter acquisition time for I-123 DaTscan and thyroid imaging.
多针孔(MPH)准直器在临床 SPECT 成像中,与传统准直器相比,在小区域和小动物成像中,具有更好的灵敏度和分辨率之间的折衷。除了这种几何优势外,MPH 板通常比传统准直器具有更好的穿透阻挡能力,这对于 I-123 成像尤其重要。I-123 除了主要发射(159keV,83%丰度)外,还会发射一系列高能(>300keV,~2.5%丰度)伽马光子。尽管其丰度较低,但高能光子比 159keV 光子更容易穿透低能平行孔(LEHR)准直器,从而导致在光电峰窗口中发生大量散射。在这项工作中,我们研究了一种常用于 I-123 甲状腺成像的单针孔准直器以及我们为帕金森病的 I-123 DaTscan 成像设计的两种 MPH 准直器的主要、散射和穿透特性,通过一系列实验和蒙特卡罗模拟,与三种不同的平行孔准直器进行了比较。点状源和具有 DaTscan 活性分布的数字人体模型的模拟表明,与平行孔和单针孔准直器相比,我们的 MPH 准直器在高主要计数、低穿透和低散射计数方面提供了更好的计数性能。例如,在 15%光电峰窗口内,LEHR 的总散射、多次散射和准直器穿透事件分别是 MPH 的 2.5、7.6 和 14 倍。LEHR 的总散射分数为 56%,最大贡献来自后腔室的高能散射(31%)。对于相同的能量窗口,MPH 的总散射分数为 21%,只有 1%的散射来自后腔室。因此,我们预计,在 I-123 DaTscan 和甲状腺成像中,使用 MPH 准直器可以在更短的采集时间内获得更高质量的重建。