Additively Manufactured Ti6Al4V-Si-Hydroxyapatite composites for articulating surfaces of load-bearing implants.

Directed-energy deposition (DED)-based additive manufacturing (AM) was explored for composite development using silicon (Si) and hydroxyapatite (HA) in Ti-6Al-4V (Ti64) matrix for articulating surfaces of load-bearing implants. Specifically, laser engineered net shaping (LENS™), a commercially available DED-based AM technique, was used to fabricate composites from premixed-feedstock powders. The AM'd composites proved to not only improve upon Ti64's mechanical properties but also produced an Si-based tribofilm during tribological testing that minimized wear induced damage. Additionally, it was found that with the introduction of Si, titanium silicides and vanadium silicides were formed; allowing for 114% increased hardness, decreased coefficient of friction (COF) and a reduction of wear rate of 38.1% and 48.7%, respectively. The produced composites also displayed a positive shift in open-circuit potential (OCP) during linear wear, along with a reduction in the change of OCP from idle to linear wear conditions. Additionally, contact resistance (CR) values increased with a maximum value of 1500 ohms due to the formation of Si-based tribofilm on the wear surface. Such composite development approach using DED-based AM can open up the possibilities of innovating next-generation implants that are designed and manufactured via multi-material AM.