Firouzmandi Maryam, Mohaghegh Mina, Jafarpisheh Maedeh
Assistant Professor, Oral and Dental Disease Research Center, Department of Operative Dentistry, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran.
Assistant professor, Department of prosthodontics, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran.
J Clin Exp Dent. 2020 May 1;12(5):e468-e473. doi: 10.4317/jced.56303. eCollection 2020 May.
Silver diamine fluoride (SDF) has attracted attention because of its clinical success in arresting dentin caries. It has been shown that it can inhibit matrix metalloproteinases and cysteine cathepsins. These two properties might be beneficial in bonding to caries-affected dentin (CAD). Therefore, the present study aimed to investigate the effect of SDF on the durability and bond strength to the CAD.
Forty-eight third molars with occlusal caries were used. The roots were cut, and the occlusal enamel was removed. The CAD area surrounded by the normal dentin (ND) was exposed. All the specimens were bonded with an etch-and-rinse adhesive, but half of them were treated with SDF after acid etching (NT or SDF). Two cylinders of composite (0.9 mm in diameter and 0.7 mm in height) were built-up on each specimen, one on the CAD and the other on the ND area. The specimens in each group (NT-ND, NT, CAD, SDF-ND, SDF-CAD) (n=24) were equally divided into two subgroups. One subgroup was tested for microshear bond strength 24 hours after bonding (T0), and the other subgroup was tested after six months of water storage (T6). The bond strength data were analyzed using three-way ANOVA. Subgroup analysis was performed using independent samples t-test. Fracture patterns were also evaluated.
At T0, the bond strength of NT-ND was higher than that of NT-CAD (<0.00), but the bond strength of SDF-ND and SDF-CAD were not different (=0.77). Comparison of the bond strength of the groups between the two time intervals yielded the following results: NT-ND-T0> NT-ND-T6 (=0.04), SDF-ND-T0=SDF-ND-T6 (=0.39), NT-CAD-T0=NT-CAD-T6 (=0.51) and SDF-CAD-T0>SDF-CAD-T6 (<0.00).
The SDF treatment increased the bond strength to CAD but did not affect the bond strength to the ND. SDF hindered the decrease in the bond strength to the ND caused by aging. However, the effect of SDF on increasing the bond strength to CAD disappeared after aging. Silver diamine fluoride, caries-affected dentin, bond strength.
由于氟化亚银(SDF)在阻止牙本质龋方面取得了临床成功,因此受到了关注。研究表明,它可以抑制基质金属蛋白酶和半胱氨酸组织蛋白酶。这两种特性可能有助于与龋损牙本质(CAD)结合。因此,本研究旨在探讨SDF对CAD的耐久性和粘结强度的影响。
使用48颗有咬合面龋的第三磨牙。将牙根切断,去除咬合面釉质。暴露由正常牙本质(ND)包围的CAD区域。所有标本均用酸蚀冲洗粘结剂粘结,但其中一半在酸蚀后用SDF处理(NT或SDF)。在每个标本上堆积两个复合树脂圆柱体(直径0.9mm,高0.7mm),一个在CAD上,另一个在ND区域。每组(NT-ND、NT、CAD、SDF-ND、SDF-CAD)(n = 24)的标本平均分为两个亚组。一个亚组在粘结后24小时(T0)测试微剪切粘结强度,另一个亚组在储存六个月后(T6)测试。使用三因素方差分析对粘结强度数据进行分析。使用独立样本t检验进行亚组分析。还评估了断裂模式。
在T0时,NT-ND的粘结强度高于NT-CAD(<0.00),但SDF-ND和SDF-CAD的粘结强度没有差异(=0.77)。两个时间间隔之间各组粘结强度的比较结果如下:NT-ND-T0 > NT-ND-T6(=0.04),SDF-ND-T0 = SDF-ND-T6(=0.39),NT-CAD-T0 = NT-CAD-T6(=0.51),SDF-CAD-T0 > SDF-CAD-T6(<0.00)。
SDF处理提高了与CAD的粘结强度,但不影响与ND的粘结强度。SDF阻碍了老化导致的与ND粘结强度的降低。然而,老化后SDF增加与CAD粘结强度的效果消失。氟化亚银,龋损牙本质,粘结强度。