Federal University of Paraíba, João Pessoa, Paraíba, Brazil.
Department of Morphology, Federal University of Paraíba, João Pessoa, Paraíba, Brazil.
J Endod. 2020 Nov;46(11):1726-1732. doi: 10.1016/j.joen.2020.07.017. Epub 2020 Jul 25.
The aim of the present study was to evaluate the morphologic changes on the apical foramen and the formation of dentinal microcracks after foraminal enlargement in straight and curved root canals using scanning electron microscopic (SEM) and micro-computed tomographic (micro-CT) analyses.
Sixty teeth were selected and divided into 2 experimental groups: GI (incisors/straight group, n = 30) and GM (molars/curved group, n = 30). Each group was divided into 2 subgroups (n = 15) according to the analysis performed: SEM or micro-CT analysis. The incisors and mesiobuccal canal of molars were instrumented with Reciproc Blue R25 instruments (VDW, Munich, Germany) using standardized shaping procedures in the apical foramen and 1 mm beyond. The occurrence of foraminal deformation was analyzed by scanning electron microscopy. The z test was used for statistical analysis (P < .05). Micro-CT imaging was used to observe the presence of microcracks in the root apical third. Afterward, pre- and postoperative cross-sectional images were screened to identify the presence of dentinal defects.
The curvature of the canal did not influence the occurrence of foraminal deformation either for instrumentation in the foramen or for instrumentation beyond the foramen (P > .05). It was also observed that the increase in the working length did not influence the appearance of new deformations in the GI/SEM and GM-SEM groups (P > .05). Qualitative micro-CT analysis showed the presence of dentinal defects in 0.8% (112) and 1.5% (208) of the cross sections of incisors and molars, respectively, from a total of 13,987 slices. All dentinal defects identified in the analysis of any postoperative scans were already present in the corresponding preoperative images. Therefore, no new microcracks were observed after root canal preparation.
The preparation of straight and moderately curved root canals with Reciproc Blue, regardless of the working length, did not influence the occurrence of apical foramen deformations and did not cause the formation of dentinal microcracks.
本研究旨在通过扫描电子显微镜(SEM)和微计算机断层扫描(micro-CT)分析评估直形和弯曲根管根尖孔扩大后根尖孔的形态变化和牙本质微裂的形成。
选择 60 颗牙齿,分为 2 个实验组:GI(切牙/直形组,n=30)和 GM(磨牙/弯曲组,n=30)。每组根据分析方法分为 2 个亚组(n=15):SEM 或 micro-CT 分析。用 Reciproc Blue R25 器械(VDW,慕尼黑,德国)对切牙和磨牙的近中颊根管进行仪器处理,在根尖孔和根尖孔后 1mm 处采用标准化的成形程序。通过扫描电子显微镜分析观察根尖孔变形的发生。采用 z 检验进行统计学分析(P<0.05)。微 CT 成像用于观察根尖三分之一处是否存在微裂。之后,筛选术前和术后的横截面图像以确定是否存在牙本质缺陷。
根管的弯曲度既不影响器械在根尖孔内的穿孔变形,也不影响器械超出根尖孔后的穿孔变形(P>.05)。此外,研究还发现,增加工作长度并不影响 GI/SEM 和 GM-SEM 组中新的变形出现(P>.05)。定性 micro-CT 分析显示,13987 个切片中,切牙和磨牙的横截面分别有 0.8%(112 个)和 1.5%(208 个)存在牙本质缺陷。所有在术后扫描分析中发现的牙本质缺陷在相应的术前图像中均已存在。因此,根管预备后未观察到新的微裂。
使用 Reciproc Blue 预备直形和中度弯曲根管,无论工作长度如何,都不会影响根尖孔的变形发生,也不会导致牙本质微裂的形成。