Suppr超能文献

氢氧化钠-水体系中纤维素溶解的凝胶阶段对基于纤维素同质多晶型物的水凝胶性能的影响

Influence of Gel Stage from Cellulose Dissolution in NaOH-Water System on the Performances of Cellulose Allomorphs-Based Hydrogels.

作者信息

Ciolacu Diana Elena, Rusu Daniela, Darie-Niţă Raluca Nicoleta, Tîmpu Daniel, Ciolacu Florin

机构信息

Department of Natural Polymers, Bioactive and Biocompatible Materials, "Petru Poni" Institute of Macromolecular Chemistry, 700487 Iasi, Romania.

Department of Physics of Polymers and Polymeric Materials, "Petru Poni" Institute of Macromolecular Chemistry, 700487 Iasi, Romania.

出版信息

Gels. 2022 Jun 29;8(7):410. doi: 10.3390/gels8070410.

Abstract

Novel hydrogels were prepared starting from different cellulose allomorphs (cellulose I, II, and III), through a swelling stage in 8.5% NaOH aqueous solution, followed by freezing at low temperature (−30 °C), for 24 h. After thawing at room temperature, the obtained gels were chemical cross-linked with epichlorohydrin (ECH), at 85 °C. The swelling degrees of the hydrogels were investigated, and a complex dependence on the type of the cellulose allomorph was found. Moreover, the gel stage has been shown to play a key role in the design of hydrogels with different performances, following the series: H-CII > H-CI > H-CIII. The correlations between the allomorph type and the morphological characteristics of hydrogels were established by scanning electron microscopy (SEM). The hydrogel H-CII showed the biggest homogeneous pores, while H-CIII had the most compacted pores network, with small interconnected pores. The rheological studies were performed in similar shear regimes, and a close correlation between the strength of the gel structure and the size of the gel fragments was observed. In the case of hydrogels, it has been shown that H-CII is softer, with a lower resistance of the hydrogel (G′) above the oscillation frequencies tested, but it maintains its stable structure, while H-CIII has the highest modulus of storage and loss compared to H-CI and H-CII, having a stronger and more rigid structure. The X-ray diffraction (XRD) method showed that the crystalline organization of each type of allomorph possesses a distinctive diffraction pattern, and, in addition, the chemically cross-linking reaction has been proved by a strong decrease of the crystallinity. Attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy provided clear evidence of the chemical cross-linking of cellulose allomorphs with ECH, by the alteration of the crystal structure of cellulose allomorphs and by the formation of new ether bands.

摘要

新型水凝胶是从不同的纤维素同质多晶型物(纤维素I、II和III)开始制备的,先在8.5%的氢氧化钠水溶液中进行溶胀阶段,然后在低温(-30°C)下冷冻24小时。在室温下解冻后,所得凝胶在85°C下用环氧氯丙烷(ECH)进行化学交联。研究了水凝胶的溶胀度,发现其对纤维素同质多晶型物的类型有复杂的依赖性。此外,凝胶阶段在设计具有不同性能的水凝胶中起着关键作用,顺序如下:H-CII > H-CI > H-CIII。通过扫描电子显微镜(SEM)建立了同质多晶型物类型与水凝胶形态特征之间的相关性。水凝胶H-CII显示出最大的均匀孔隙,而H-CIII具有最致密的孔隙网络,孔隙相互连接且较小。在相似的剪切条件下进行了流变学研究,观察到凝胶结构强度与凝胶碎片大小之间存在密切相关性。在水凝胶的情况下,已表明H-CII较软,在所测试的振荡频率以上水凝胶的阻力较低(G′),但它保持其稳定结构,而与H-CI和H-CII相比,H-CIII具有最高的储能模量和损耗模量,具有更强且更刚性的结构。X射线衍射(XRD)方法表明,每种同质多晶型物的晶体结构都具有独特的衍射图案,此外,化学交联反应通过结晶度大幅下降得到证明。衰减全反射傅里叶变换红外(ATR-FTIR)光谱通过纤维素同质多晶型物晶体结构的改变和新醚带的形成,提供了纤维素同质多晶型物与ECH发生化学交联的明确证据。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/6a0f/9322726/12703035e88d/gels-08-00410-g001.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验