Tianjin Medical University, Tianjin, China.
Tianjin Hospital, Tianjin, China.
Orthop Surg. 2023 Feb;15(2):579-590. doi: 10.1111/os.13395. Epub 2022 Dec 1.
To explore the potential effect of three allogenic bone substitute configurations on the viability, adhesion, and spreading of osteoblasts in vitro.
Freeze-dried cortical bone were ground and fractions were divided into three groups with different sizes and shapes, defined as bone fiber (0.1 mm × 0.1 mm × 3 mm), bone powder (0.45-0.9 mm), and bone granule group (3-6 mm). MC3T3-E1 cells were divided and co-cultured within groups to induce cell adhesion. The configuration of allogenic bone was captured by scanning electron microscopy and confocal laser scanning microscopy, and substrate roughness values were quantified. Cell adhesion rate was assessed using the hemocyte counting method, cell viability was determined by CCK-8 assay and live/dead staining, and cell morphology was visualized by Phalloidin and DAPI, and the mRNA expression of adhesion-related gene (vinculin) of different substitutes were determined with quantitative real-time polymerase chain reaction.
The roughness values of bone fiber, bone powder, and bone granule group were 1.878 μm (1.578-2.415 μm), 5.066 μm (3.891-6.162 μm), and 0.860 μm (0.801-1.452 μm), respectively (bone powder group compared with bone granule group, H = 18.015, P < 0.001). Similar OD values of all groups in CCK-8 assay indicated good biocompatibility of these substitutes (bone fiber, 0.201 ± 0.004; bone powder, 0.206 ± 0.008; bone granule group, 0.197 ± 0.006; and the control group, 0.202 ± 0.016, F = 0.7152, P > 0.05). In addition, representative cell adhesion rates at 24 h showed significantly lower cell adhesion rate in bone fiber group (20.3 ± 1.6%) compared to bone powder (29.3 ± 4.4%) and bone granule group (27.3 ± 3.2%) (F = 10.51,P = 0.009 and P = 0.034, respectively), but there was no significant difference between the latter two groups (P > 0.05). Interestingly, the expression of vinculin mRNA steadily decreased in a time-dependent manner. The vinculin expression reached its peak at 6 h in each group, and the vinculin levels in bone fiber, bone powder, and bone granule group were 2.119 ± 0.052, 3.842 ± 0.108, and 3.585 ± 0.068 times higher than those in the control group, respectively (F = 733.643, all P < 0.001). Meanwhile, there was a significant difference in the expression of target gene between bone powder and bone granule group (P = 0.006).
All allogenic bone substitutes presented an excellent cell viability. Moreover, bone powder and bone granule group were more likely to promote cell adhesion and spreading compared to bone fiber group.
探讨 3 种同种异体骨替代物构型对体外成骨细胞活力、黏附及铺展的潜在影响。
冻干皮质骨经研磨后分为 3 组,大小和形状不同,分别定义为骨纤维(0.1mm×0.1mm×3mm)、骨粉(0.45-0.9mm)和骨粒组(3-6mm)。MC3T3-E1 细胞分组并共培养以诱导细胞黏附。用扫描电子显微镜和共聚焦激光扫描显微镜观察同种异体骨的构型,量化基质粗糙度值。采用血细胞计数法评估细胞黏附率,用 CCK-8 法和活/死染色法测定细胞活力,用鬼笔环肽和 DAPI 观察细胞形态,用实时定量聚合酶链反应检测不同替代物中黏附相关基因(波形蛋白)的 mRNA 表达。
骨纤维、骨粉和骨粒组的粗糙度值分别为 1.878μm(1.578-2.415μm)、5.066μm(3.891-6.162μm)和 0.860μm(0.801-1.452μm)(骨粉组与骨粒组比较,H=18.015,P<0.001)。CCK-8 检测中所有组的 OD 值相似,表明这些替代物具有良好的生物相容性(骨纤维组为 0.201±0.004,骨粉组为 0.206±0.008,骨粒组为 0.197±0.006,对照组为 0.202±0.016,F=0.7152,P>0.05)。此外,24 h 时代表性的细胞黏附率显示,骨纤维组(20.3%±1.6%)的细胞黏附率明显低于骨粉组(29.3%±4.4%)和骨粒组(27.3%±3.2%)(F=10.51,P=0.009 和 P=0.034),但后两组之间无显著差异(P>0.05)。有趣的是,波形蛋白 mRNA 的表达呈时间依赖性逐渐下降。各组在 6 h 时达到表达峰值,骨纤维、骨粉和骨粒组的波形蛋白水平分别比对照组高 2.119±0.052、3.842±0.108 和 3.585±0.068 倍(F=733.643,均 P<0.001)。同时,骨粉组和骨粒组之间目标基因的表达存在显著差异(P=0.006)。
所有同种异体骨替代物均表现出良好的细胞活力。此外,与骨纤维组相比,骨粉组和骨粒组更有利于促进细胞黏附和铺展。