Zierdt C H
Appl Environ Microbiol. 1979 Dec;38(6):1166-72. doi: 10.1128/aem.38.6.1166-1172.1979.
Strong adherence of bacteria, yeast, erythrocytes, leukocytes, platelets, spores, and polystyrene spheres to membrane filter materials was noted during filtration through membranes with pore size diameters much larger than the particles themselves. Quantitative recovery on the membrane filters of these particles from low-concentration suspensions was achieved during gravity- or vacuum-assisted filtration through membranes with pore diameters as much as 30 times that of the filtered particles. Mechanical sieving was not responsible. The phenomenon was judged to be electrostatic. It could be partially blocked by pretreating the filter with a nonionic surfactant (Tween 20), and elution of adherent particles was achieved with 0.05% Tween 20. Gram-positive cocci were removed from suspension more efficiently than gram-negative rods. The commonly used cellulose membranes adsorbed more bacteria, blood cells, and other particles than did polycarbonate filters. Of lesser adsorptive capacity were vinyl acetate, nylon, acrylic, and Teflon membranes. Backwashing with saline, serum, 6% NaCl, dextran solutions, or phosphate buffers of varying molality and pH removed only a fraction of adherent particles. Tween 20 (0.05%) eluted up to 45% of adherent particles in a single back-filtration. Selected filters quantitatively removed the particles tested, which then could be washed and subjected to reagents for a variety of purposes. It is important to anticipate the removal of particles during membrane filtration, since it is not a simple mechanical event.
在通过孔径直径远大于颗粒本身的膜进行过滤时,发现细菌、酵母、红细胞、白细胞、血小板、孢子和聚苯乙烯球体对膜过滤材料有强烈的粘附。在重力或真空辅助过滤过程中,通过孔径达被过滤颗粒孔径30倍的膜,可实现从低浓度悬浮液中定量回收这些颗粒。这并非机械筛分所致。该现象被判定为静电作用。用非离子表面活性剂(吐温20)预处理过滤器可部分阻止这种现象,用0.05%吐温20可洗脱粘附颗粒。革兰氏阳性球菌比革兰氏阴性杆菌更有效地从悬浮液中被去除。常用的纤维素膜比聚碳酸酯过滤器吸附更多的细菌、血细胞和其他颗粒。醋酸乙烯酯、尼龙、丙烯酸和聚四氟乙烯膜的吸附能力较弱。用盐水、血清、6%氯化钠、葡聚糖溶液或不同摩尔浓度和pH值的磷酸盐缓冲液进行反冲洗,只能去除一部分粘附颗粒。在一次反滤中,0.05%的吐温20可洗脱高达45%的粘附颗粒。选定的过滤器可定量去除测试颗粒,然后可对其进行清洗并用于各种目的的试剂处理。由于膜过滤过程并非简单的机械过程,因此预测颗粒的去除情况很重要。