Suppr超能文献

通过冷冻蚀刻电子显微镜检测大肠杆菌膜泡的取向

Orientation of membrane vesicles from Escherichia coli as detected by freeze-cleave electron microscopy.

作者信息

Altendorf K H, Staehelin L A

出版信息

J Bacteriol. 1974 Feb;117(2):888-99. doi: 10.1128/jb.117.2.888-899.1974.

Abstract

The application of freeze-cleave electron microscopy to whole cells of Escherichia coli revealed that the particles exposed on the resulting two inner membrane faces are asymmetrically distributed. This method can therefore be used to determine the orientation of membrane vesicles from E. coli. Membrane vesicles freshly prepared in potassium phosphate buffer (K(+)-vesicles) by osmotic lysis of spheroplasts consisted almost entirely of right-side-out vesicles. Their size suggested that each cell gives rise to one vesicle. When the membrane vesicles were subjected to one cycle of freezing and thawing, the number of inside-out vesicles rose to about 25%. However, due to the small size of most of the inside-out vesicles, these contribute only 2 to 3% of the total membrane surface area of the preparation. The inside-out vesicles appear to arise from infoldings of the membrane of right-side-out vesicles. They also accumulate within the latter, thus producing multivesicular membrane sacs. Na(+)-vesicles (vesicles prepared in sodium phosphate buffer) subjected to freezing and thawing appeared to lose structural rigidity more than did K(+)-vesicles. In contrast to the membrane vesicles prepared by the osmotic lysis of spheroplasts, those obtained by breaking intact cells by a single passage through a French pressure cell were uniformly very small (only 40 to 110 nm in diameter); approximately 60 to 80% were inside-out. To reconcile the polarity of the membrane vesicles with the enzymic activities of such preparations, we propose that "dislocation" of membrane proteins occurs during osmotic lysis of spheroplasts.

摘要

将冷冻断裂电子显微镜技术应用于大肠杆菌的全细胞,结果显示,在由此产生的两个内膜面上暴露的颗粒分布不对称。因此,该方法可用于确定来自大肠杆菌的膜泡的取向。通过原生质球的渗透裂解在磷酸钾缓冲液中新鲜制备的膜泡(K⁺-膜泡)几乎完全由外翻膜泡组成。它们的大小表明每个细胞产生一个膜泡。当膜泡经历一轮冻融时,内翻膜泡的数量上升到约25%。然而,由于大多数内翻膜泡尺寸较小,它们仅占制剂总膜表面积的2%至3%。内翻膜泡似乎源自外翻膜泡膜的内褶。它们也在后者内部聚集,从而产生多囊膜囊。经历冻融的Na⁺-膜泡(在磷酸钠缓冲液中制备的膜泡)似乎比K⁺-膜泡更易失去结构刚性。与通过原生质球渗透裂解制备的膜泡不同,通过单次通过法国压榨器破碎完整细胞获得的膜泡普遍非常小(直径仅40至110nm);大约60%至80%是内翻的。为了使膜泡的极性与这类制剂的酶活性相协调,我们提出膜蛋白的“错位”发生在原生质球的渗透裂解过程中。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验