Suppr超能文献

用于修复腹壁缺损的假体材料比较。

A comparison of prosthetic materials used to repair abdominal wall defects.

作者信息

Jenkins S D, Klamer T W, Parteka J J, Condon R E

出版信息

Surgery. 1983 Aug;94(2):392-8.

PMID:6224307
Abstract

A large abdominal wall hernia, not amenable to primary closure, may require insertion of a prosthesis. The ideal prosthesis maintains strength, is incorporated by surrounding tissues, and does not stimulate adhesions. These qualities vary among available synthetic prostheses. We tested tensile strength, bursting strength, and adhesion formation in response to six materials used in repair of abdominal wall hernias. Adult Sprague-Dawley rats (196) were randomly divided into a control group and six experimental groups. A 4 by 4 cm full-thickness resection of abdominal wall was closed with patches of polypropylene mesh (Marlex), polyglactin 910 mesh (Vicryl), expanded polytetrafluoroethylene (Gore-tex), Dacron-reinforced silicone rubber (Silastic), preserved human dura (PHD), or polypropylene mesh overlying gelatin film (Marlex and Gelfilm, respectively). In controls the 4 cm longitudinal full-thickness incisions were closed primarily. Seven rats randomly selected from each group were sacrificed after 1, 2, 4, and 8 weeks; bursting and tensile strength (tensiometer) and adhesion formation were assessed. There were no differences in bursting strength among the experimental groups at each testing period. Although bursting strength increased linearly with time it was significantly weaker than in controls at 1 and 8 weeks (P less than 0.05). Tensiometric data were inconclusive due to wide variability within the experimental groups. Adhesion formation was moderate to maximal at all evaluation periods for Marlex and Gore-tex. Early adhesion formation was minimal to moderate for both PHD and Vicryl, but later increased with PHD and decreased with Vicryl as this prosthesis was absorbed. No adhesions formed with Marlex and Gelfilm until the gelatin dissolved (1 week), after which the adhesion response was similar to that with Marlex alone. No adhesions formed after Silastic implantation, but graft extrusion and evisceration were common (75%). Controls had no adhesions at all evaluation periods. Wound strength was similar for all prosthetic materials. Absorbable prosthetic Vicryl provided the best long-term protection against adhesions.

摘要

对于无法进行一期缝合的大型腹壁疝,可能需要植入假体。理想的假体应保持强度,能被周围组织包绕,且不会刺激粘连形成。这些特性在现有的合成假体中各不相同。我们测试了用于腹壁疝修补的六种材料的抗张强度、破裂强度和粘连形成情况。将196只成年Sprague-Dawley大鼠随机分为对照组和六个实验组。用聚丙烯网片(Marlex)、聚乙醇酸910网片(Vicryl)、膨体聚四氟乙烯(Gore-tex)、涤纶增强硅橡胶(Silastic)、保存的人硬脑膜(PHD)或覆盖明胶膜的聚丙烯网片(分别为Marlex和Gelfilm)修补4×4 cm的腹壁全层切除缺损。对照组的4 cm纵向全层切口进行一期缝合。每组随机选取7只大鼠,分别在1、2、4和8周后处死;评估破裂强度和抗张强度(张力计)以及粘连形成情况。在每个测试期,各实验组的破裂强度无差异。尽管破裂强度随时间呈线性增加,但在1周和8周时明显低于对照组(P<0.05)。由于实验组内差异较大,张力测量数据尚无定论。Marlex和Gore-tex在所有评估期的粘连形成程度为中度至重度。PHD和Vicryl早期粘连形成程度为轻度至中度,但随着PHD的吸收粘连程度后期增加,而Vicryl则减少。Marlex和Gelfilm在明胶溶解前(1周)未形成粘连,之后的粘连反应与单独使用Marlex相似。Silastic植入后未形成粘连,但移植物挤出和内脏脱出很常见(75%)。对照组在所有评估期均无粘连。所有假体材料的伤口强度相似。可吸收假体Vicryl在预防粘连方面提供了最佳的长期保护。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验