Suppr超能文献

在液体冷却剂中对小组织块进行冷冻淬火的最佳条件。

Optimum conditions for cryoquenching of small tissue blocks in liquid coolants.

作者信息

Elder H Y, Gray C C, Jardine A G, Chapman J N, Biddlecombe W H

出版信息

J Microsc. 1982 Apr;126(Pt 1):45-61. doi: 10.1111/j.1365-2818.1982.tb00356.x.

Abstract

Three approaches were taken with the aim of defining the optimum conditions of rapid cryopreservation in liquid quenchants. In a theoretical approach, two mathematical models were used. The first is of value in defining the absolute maximum rates of cooling which could be achieved at various depths in the tissues. The second highlights the poor thermal properties of liquid coolants and therefore emphasizes the essential requirement for vigorous quenchant mixing and rapid specimen entry. Experimental work with thermocouples showed that fastest cooling rates occur at the leading edge of the object entering coolant. Of five quenchants investigated, cooling rates were in the order, propane greater than Freon 22 greater than Freon 12 greater than liquid nitrogen slush greater than liquid nitrogen. Other considerations, however, may affect the choice of quenchant. For a given quenchant, cooling rate is maximal near the equilibrium freezing point. The consequences of quenching in the presence of thermal gradients either within the coolant or in the gas layer above it are shown. Cooling rate was found to be approximately proportional to entry velocity at least up to approximately 2 m s-1 in our system. Stereological analysis of rapidly quenched, freeze-substituted tissue samples, of geometry which imposed an approximately unidirectional heat flow, revealed four zones: (i) a narrow surface layer (approximately 10 micrometers) of low image contrast and apparent of ice crystals; (ii) a zone of enhanced contrast with ice crystals whose size increased rapidly with depth from the surface (the 'slope'); (iii) a sharply defined zone (the 'ridge') of maximum ice crystal size beyond which there is (iv) an extensive 'plateau' with smaller ice crystals and no marked increase in size with depth. The 'ridge' of maximal ice-crystal damage was consistently found but varied considerably in depth from the surface (approximately 25-120 micrometers) between samples. The existence of the deeper plateau region of relatively uniform ice-crystal-size may be of significance in X-ray microanalytical studies of physiological processes at some depth from the sample surface. In terms of our present understanding of the quenching process, the conditions for optimal cryofixation of small tissue samples are listed.

摘要

为了确定在液体淬火剂中快速冷冻保存的最佳条件,采取了三种方法。在理论方法中,使用了两个数学模型。第一个模型对于定义在组织不同深度处可实现的绝对最大冷却速率很有价值。第二个模型突出了液体冷却剂较差的热性能,因此强调了剧烈搅拌淬火剂和快速放入标本的基本要求。用热电偶进行的实验表明,最快的冷却速率出现在物体进入冷却剂的前沿。在所研究的五种淬火剂中,冷却速率的顺序为:丙烷>氟利昂22>氟利昂12>液氮淤浆>液氮。然而,其他因素可能会影响淬火剂的选择。对于给定的淬火剂,冷却速率在平衡凝固点附近最大。展示了在冷却剂内部或其上方气体层中存在热梯度时淬火的后果。在我们的系统中,发现冷却速率至少在约2 m s-1之前与放入速度大致成正比。对快速淬火、冷冻置换的组织样本进行体视学分析,样本的几何形状导致热流近似单向,结果显示有四个区域:(i) 一个狭窄的表面层(约10微米),图像对比度低且明显有冰晶;(ii) 一个对比度增强的区域,其中冰晶尺寸从表面开始随深度迅速增加(“斜坡”);(iii) 一个冰晶尺寸最大的清晰界定区域(“脊”),在此之外是(iv) 一个有较小冰晶且尺寸随深度无明显增加的广阔“高原”区域。始终能发现最大冰晶损伤的“脊”,但不同样本之间其距表面的深度差异很大(约25 - 120微米)。相对均匀冰晶尺寸的较深高原区域的存在,对于在距样本表面一定深度处进行生理过程的X射线微分析研究可能具有重要意义。根据我们目前对淬火过程的理解,列出了小组织样本最佳冷冻固定的条件。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验